1) scan efficiency
扫描效率
1.
This expression may be used as an indirect testing method of scan efficiency η.
红外成像系统的扫描效率η与系统的噪声等效温差(NETD)有关。
2) scanning of detection efficiency
探测效率扫描
3) horizontal efficiency
水平扫描效率
4) scan rate
扫描速率
1.
Effect of scan rate on nonafriction properties of monolayer molecular deposition film on silicon;
扫描速率对硅表面分子沉积膜纳米摩擦特性的影响
2.
In addition,the effect of scan rate on peak current and potential was studied when a film CuX was formed,and the mechanism of dissolution o.
通过比较Cu在卤离子溶液与含 (NH2 ) 2 CS卤离子溶液中的电化学行为 ,解释了 (NH2 ) 2 CS的缓蚀机制 ;并研究了扫描速率对形成CuX膜的峰电位和峰电流的影响 ,探讨了Cu的阳极溶解机
5) Frequency sweep
频率扫描
1.
The direct digital synthesizing frequency sweep signal system based on the technique of ISP;
基于ISP技术的数字频率扫描信号发生系统
2.
In the linear viscoelastic region, the frequency sweep measurement results showed that the waste liquor polymer solution has viscoelasticity.
在线性粘弹性范围内,频率扫描试验得出:甘蔗渣浆废液多聚物是具有一定粘弹性的粘弹体,增加固含量和提高温度都会提高复合模量G*,粘弹性更突出。
3.
A novel method of direct digital synthesizing frequency sweep signal is presented.
介绍了利用直接数字合成技术产生频率扫描信号的新方法。
6) scanning rate
扫描速率
1.
The performance test of MOD300 distributed control system is described in this paper and an analysis on the test results of 3 primary performance indexes——system response time, scanning rate and CPU load rate——was carried out.
本文介绍了北仑电厂1号机MOD300分散控制系统性能测试的情况,并对三个主要性能指标:响应时间、扫描速率和CPU负荷率的测试结果作了分析,对如何提高系统响应速度、降低CPU负荷率提出了建议。
2.
It was focused on design of the optimization about the parameters on the selective laser sintering processing,such as scanning rate,power of sintering and preheated temperature.
对ABS粉末塑料的选区激光烧结过程的成型工艺参数进行了优化设计,对其中影响最大的参数(扫描速率、激光功率、预热温度)的匹配以及成型参数的选择进行了优化设计,得出一组最佳组合的工艺参数。
补充资料：扫描电子显微镜(见扫描电子显微术)
扫描电子显微镜(见扫描电子显微术)
scanning eleetron mieroseoPe
扫描电子显微镜scanning eleetron mieroseope见扫描电子显微术。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条