1) Injury of steelmaking furnaces explosion
炼钢炉爆炸伤
2) explosive wound
爆炸伤
1.
Detection of IL-1、IL-6、TNF-α and CRP in explosive wound;
爆炸伤创面IL-1、IL-6、TNF-α、CRP的测定
2.
Methods Explosive wounds were made at the knee joints of 36 New Zealand white rabbits with a 0.
目的观察海水浸泡的兔髌韧带爆炸伤修复的组织学变化。
3.
Results:Explosive wounds were serious, complex with multiple tissue and organs injury, the wound usually occurred in head and limbs, and the combined injury was higher than that of gunshot wound.
结果 :爆炸伤一般伤情复杂、污染重 ;受伤组织和器官多 ,损伤以头颈部和四肢破片伤为主 ;盲管伤、多发伤、合并伤多 ;一般较枪弹伤损伤复杂。
3) explosive wounds
爆炸伤
1.
Mechanism of primary and secondary injury in lung injury of chest explosive wounds;
胸部爆炸伤后原发和继发性肺损伤机制研究
2.
Therapeutic effect of sustained release compound tablet containing anti-bacterial and anti-inflammatory drugs on explosive wounds in rabbit limbs;
抗菌抗炎药物的甲壳素缓释片在兔肢体软组织爆炸伤早期处理中的应用
4) Explosive injury
爆炸伤
1.
Changes of IL-6, IL-8 and TNFα levels following explosive injury to rabbits chest;
兔胸部爆炸伤后早期IL-6、IL-8和TNFα水平的变化
2.
Study on the blast injury of lung combined with explosive injury in maxillofacical region;
颌面部爆炸伤(弹冲复合伤)致肺损伤的实验研究
3.
Effects of exogenous hydrogen sulfide on secondary lung damage after explosive injury of limbs in rats;
外源性硫化氢对大鼠肢体爆炸伤后继发性肺损伤的作用
5) Blast injury
爆炸伤
1.
Vacuum-assisted closure alleviate secondary tissue necrosis of pig′s infected soft tissue blast injury;
封闭负压引流技术对猪皮肤软组织爆炸伤感染创面继发性坏死的影响
2.
Comparison of experimental study of oromaxillofacial blast injury and firearm injury;
口腔颌面部爆炸伤与枪弹伤的对比实验研究
3.
Study on vacuum-assisted closure accelerated granulation tissue formation in pig s infected soft tissue blast injury;
封闭负压引流促进猪皮肤软组织爆炸伤感染创面的血管生成
6) Explosion injury
爆炸伤
1.
Clinical Experience on Treating 17 Cases of Explosion Injury;
爆炸伤治疗探讨(附17例报告)
2.
Methods 128 Wistar rats were randomly divided into 4 groups which were normal control group(n=8),simple burn group(n=40),explosion injury group(n=40),and burn combined explosion group(n=40).
方法W istar大鼠128只,随机分为正常对照组(n=8)、烧伤组(n=40)、爆炸伤组(n=40)和复合伤组(n=40),分别致伤形成大鼠20%体表面积Ⅲ度烧伤、火药爆炸伤和两者复合伤。
3.
Methods The adrenal cortex and the thyroid after explosion injury were observed by light and electron microscopy.
方法 对大鼠爆炸伤后不同时相点的肾上腺和甲状腺进行光、电镜观察。
补充资料：炼钢炉炉壳安装
炼钢炉炉壳安装
erection of furnace shell for steelmaking furnace
托圈进行板式连接，最后再用倾翻机构将炉壳回转18扩成为正装状态。彝· 图1转炉壳体下装法安装示意 1一托圈;2一上、中部炉亮;3一下部炉壳.4一驱动侧轴 承座底座;5一非驱动侧轴承座底座;6一连接装!.7一 墓础;8一安装架，9一台车;1。一轨道 电弧炉炉体结构安装电弧炉炉体结构主要由炉壳、炉盖圈、轨座、弧形摇架、旋转框架及平台等构件组成(图2)。赢1 图2整体式炉盖旋开式电弧炉炉体结构图 1一轨座;2一弧形板;3一摇架平台;4一炉亮;5一炉盖. 6一除尘草，7一旋转框架平台;8一旋转框架;9一电极立 柱支架;1。一出铜槽;11一摇架锁定装! 电弧炉炉壳分炉身、炉底和加固圈三部分。炉底有平底、锥底及球形底三种，炉壳制造分整体式和剖分 式。炉容量从0.5t到30。多饥炉壳材质一般为普通低 碳钢，当炉底装有电磁搅拌装置时，炉底壳为耐热不锈 钢或弱磁性钢，轨座、摇架等多为板材拼焊结构。 炉体结构安装顺序通常为:基础验收~测定纵、 横中心线和标高~座浆垫板敷设，轨座安装，弧形摇 架及平台安装~倾动锁紧定位装置安装~电磁搅拌装 置安装~炉壳组合安装冲旋转框架及平台安装~电极 立柱支架安装。_…襄搏纷: 板一般为分片供货，应先在装配平台上进行组装，焊接 成环节后，再吊装到摇架上进行总装配和环缝焊接·安一鬓靛撰蒸器蒸:几- 求。 平炉炉体结构安装平护炉体结构由上部结构 (炉膛、炉头)、下部结构(沉渣室、蓄热室)及平台组 成。炉膛分固定式和倾动式.两种。平炉容量为10一 900t。平护构件由型钢、扁钢及板材制成，个别部件为 铸钢制品，材质多为低碳钢，.构件接口可采取螺栓连…狱 热室或沉渣室时，应先将底盘吊装就位并找正后紧固 地脚螺栓了然后吊装端墙、侧墙部件，按要求调整墙柱 间距离、标高、垂直度及对角线后，将各部件联结固定; 最后安装顶盘，找正定心后紧固。在顶盘上安装炉头底 盘框架，并精确定位联结。安装炉膛结构时，应先从下 至上逐次将炉底下部结构件吊装到基础上，_井按炉体 的纵、横中心线及基准点对炉底结构进行找平、找正、1 iangang!u luke anz卜uang炼钢炉炉壳安装(ereetion of furnaee shellfor steelmaking furnaee)将炼钢炉的壳体构件按照设计和施工技术标准进行组对安装的施工作业。 炼钢炉主要有转炉、电弧炉和平炉三种。转炉、电弧炉的壳体是用钢板焊成的筒形结构;平炉壳体是用型钢、扁钢和钢板制成的框架结构。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条