拔出术,extraction,在线英语词典,英文翻译,专业英语

1) extraction

拔出术

Objective The purpose of this study is to investigate the effect of α-tricalcium phosphate cememts after impacted mandibular third molar extraction.

结果α-磷酸三钙骨水泥能减轻阻生牙拔出术后反应,X线观察α-磷酸三钙骨水泥植入后1周时见拔牙创内人工骨定植,1个月后拔牙创基本愈合。

2) pullout

拔出

This paper presents the results of 28 pullout bond tests on fiber reinforced polymer FRP bars embedded in concrete.

进行了28个纤维聚合物(FRP)筋拔出粘结试验,试验变量为FRP筋种类、FRP筋直径、混凝土强度和粘结长度,拔出试验记录了拔出荷载、FRP筋加载端滑移、破坏现象。

Finite element method was used to analyze the stresses in the whisker - matrix interface of Al2O3/SiCw ceramic comPOsite when whisker pullout was occurred, the stresses distribution was also obtained.

采用有限元的方法分析了Ａｌ_２Ｏ_３／ＳｉＣ_ｗ陶瓷材料晶须拔出时材料中的应力状态及应力分布，研究了晶须拔出时材料界面的断裂模式。

3) pull-out

拔出

Mechanical behavior in the pull-out process of NiTi SMA fiber;

NiTi形状记忆合金纤维拔出中的力学问题

The distribution of normal stress in fiber and interfacial shear stress were obtained as well as the axial pull-out force.

5 mm)拔出为例,对橡胶-纤维复合材料不同温度下的界面力学性能进行了数值分析,得到了相应的应力场分布和拔出载荷的变化。

The interface properties of nylon fiber-rubber composites were studied by using single fiber pull-out method.

采用单纤维拔出的方法,研究了不同温度下尼龙纤维-橡胶复合材料的界面特性。

4) yield

拔出率

The results showed that the total yield could increased evidently with the outlet temperature of vaccum furnace increasing,and there was room for the outlet temperature raising.

采用Petro-SIMTM软件对减压炉的模拟结果表明,提升减压炉出口温度能明显提高减压总拔出率,且减压炉有较大提温余地。

Therefore the yield in the vacuum still raises 2.

在某厂常减压装置节能技术改造及减压塔更新设计中,运用“微湿式”减压蒸馏技术,减压塔采用了新型规整填料、槽盘式气液分布器、进料分布器等新技术,使装置操作平稳,处理量增大,减压塔拔出率提高了2。

The total yield of the VGO is in the range of 65%～76%.

在系统压力 6Pa和温度 2 80、 30 0和 32 0℃的条件下 ,采用实验室高真空短程蒸馏仪对辽河、鲁宁管输和大庆原油的常压渣油进行深拔 ,减压馏分油 (VGO)总拔出率 (质量分数 )可达 6 5 %～ 76 %。

5) single fiber pull-out test

单丝拔出

In this work,silane coupling agents were used for the surface treatment-of theKevlar-49 fibers,the interfacial strength was studied by means of single fiber pull-out tests.

用单丝拔出实验研究了以有机硅表面处理剂处理的Ｋｅｖｌａｒ－４９－环氧树脂体系界面相。

6) pullout force

拔出力

The maximum pullout force of the layered microstructure of the hydroxyapatite sheets were investigated through its representative model and a comparative experiment.

基于在胫骨中观察到的羟基磷灰石片的微结构特征,通过微结构模型分析及实验,研究了这种微结构的最大拔出力。

参考词条

拔出强度拔出载荷拔出法拔出量后装拔出拔出插头拔出长度拔出分析拔出实验桥纤维拔出高密度电法测量系统交通流流量

补充资料：出后

1.出继，过继给他人为后代。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。

首页 \| 翻译 \| 影视 \| 论坛 \| 索引纤维拔出拔出试验拔出行为界面拔出晶须拔出抗拔出力

1) extraction 拔出术 1. Objective The purpose of this study is to investigate the effect of α-tricalcium phosphate cememts after impacted mandibular third molar extraction. 结果α-磷酸三钙骨水泥能减轻阻生牙拔出术后反应,X线观察α-磷酸三钙骨水泥植入后1周时见拔牙创内人工骨定植,1个月后拔牙创基本愈合。 2) pullout 拔出 1. This paper presents the results of 28 pullout bond tests on fiber reinforced polymer FRP bars embedded in concrete. 进行了28个纤维聚合物(FRP)筋拔出粘结试验,试验变量为FRP筋种类、FRP筋直径、混凝土强度和粘结长度,拔出试验记录了拔出荷载、FRP筋加载端滑移、破坏现象。 2. Finite element method was used to analyze the stresses in the whisker - matrix interface of Al2O3/SiCw ceramic comPOsite when whisker pullout was occurred, the stresses distribution was also obtained. 采用有限元的方法分析了Ａｌ_２Ｏ_３／ＳｉＣ_ｗ陶瓷材料晶须拔出时材料中的应力状态及应力分布，研究了晶须拔出时材料界面的断裂模式。 3) pull-out 拔出 1. Mechanical behavior in the pull-out process of NiTi SMA fiber; NiTi形状记忆合金纤维拔出中的力学问题 2. The distribution of normal stress in fiber and interfacial shear stress were obtained as well as the axial pull-out force. 5 mm)拔出为例,对橡胶-纤维复合材料不同温度下的界面力学性能进行了数值分析,得到了相应的应力场分布和拔出载荷的变化。 3. The interface properties of nylon fiber-rubber composites were studied by using single fiber pull-out method. 采用单纤维拔出的方法,研究了不同温度下尼龙纤维-橡胶复合材料的界面特性。 4) yield 拔出率 1. The results showed that the total yield could increased evidently with the outlet temperature of vaccum furnace increasing,and there was room for the outlet temperature raising. 采用Petro-SIMTM软件对减压炉的模拟结果表明,提升减压炉出口温度能明显提高减压总拔出率,且减压炉有较大提温余地。 2. Therefore the yield in the vacuum still raises 2. 在某厂常减压装置节能技术改造及减压塔更新设计中,运用“微湿式”减压蒸馏技术,减压塔采用了新型规整填料、槽盘式气液分布器、进料分布器等新技术,使装置操作平稳,处理量增大,减压塔拔出率提高了2。 3. The total yield of the VGO is in the range of 65%～76%. 在系统压力 6Pa和温度 2 80、 30 0和 32 0℃的条件下 ,采用实验室高真空短程蒸馏仪对辽河、鲁宁管输和大庆原油的常压渣油进行深拔 ,减压馏分油 (VGO)总拔出率 (质量分数 )可达 6 5 %～ 76 %。 5) single fiber pull-out test 单丝拔出 1. In this work,silane coupling agents were used for the surface treatment-of theKevlar-49 fibers,the interfacial strength was studied by means of single fiber pull-out tests. 用单丝拔出实验研究了以有机硅表面处理剂处理的Ｋｅｖｌａｒ－４９－环氧树脂体系界面相。 6) pullout force 拔出力 1. The maximum pullout force of the layered microstructure of the hydroxyapatite sheets were investigated through its representative model and a comparative experiment. 基于在胫骨中观察到的羟基磷灰石片的微结构特征,通过微结构模型分析及实验,研究了这种微结构的最大拔出力。参考词条拔出强度拔出载荷拔出法拔出量后装拔出拔出插头拔出长度拔出分析拔出实验桥纤维拔出高密度电法测量系统交通流流量补充资料：出后 1.出继，过继给他人为后代。说明：补充资料仅用于学习参考，请勿用于其它任何用途。
©2008 dictall.com