说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 电流馈电推挽变换器
1)  current-fed push-pull converter
电流馈电推挽变换器
1.
A current feedback control method for regulating output voltage among multiple outputs of buck current-fed push-pull converter is presented in this paper.
本文提出了一种应用于多输出BUCK电流馈电推挽变换器的电流反馈控制方法。
2)  push-pull current
推挽电流
3)  push-pull converter
推挽变换器
1.
In this paper,voltage loop and peak-value current loop are used to control a high power DC/DC converter,one strategy to eliminate the transformer magnetic bias is proposed,3 kW push-pull converter is designed and MATLAB verifys the strategy of eliminating the transformer magnetic bias.
利用了电压环和峰值电流环控制大功率推挽DC/DC变换器,提出消除主变偏磁的策略,设计了3kW推挽变换器,利用MATLAB仿真验证了该控制策略可以消除主变偏磁。
2.
The Boost converter with transformer-isolated was used in Boost mode,which was cascaded by a Boost converter and a push-pull converter,eliminating the redundancy com-ponents by a control strategy,a novel step-up circuit topology was formed.
提出了一种新颖的双向DC/DC变换器,降压时采用移相控制ZVZCS-PWM全桥功率变换,控制简单,效率较高,升压时采用带变压器隔离的Boost变换器,利用Boost变换器与推挽变换器的级联,通过一种控制策略,去掉冗余元件,得到一种新颖的升压电路拓扑。
3.
There are some intrinsic drawbacks in traditional push-pull converter,such as higher voltagestress and hard-switching of the switches,so the application area of the converter is limited.
传统的推挽变换器存在着一些固有的缺点,诸如开关管的电压应力高、难以实现软开关等,限制了它的应用范围。
4)  converter-side current feedback
变换器侧电流反馈
1.
Analysis and simulation results show that it has less harmonic current and better stability with converter-side current feedback control structure than that with grid-side current feedback control structure,but with the latter structure it is simpler and easier to realize unity power factor control.
为分析基于LCL滤波器的双馈风电网侧变换器在不同电流反馈控制结构情况下的工作性能,采取PI控制器对网侧变换器网侧电流反馈控制结构和变换器侧电流反馈控制结构的电流闭环根轨迹进行分析,对其在理想电网无阻尼电阻和有阻尼电阻、非理想电网无阻尼电阻3种情况下的特性进行了比较。
5)  push-pull voltage source inverter
推挽式电压源逆变器
6)  push-pull converter
推挽式变换器
1.
A switching power is designed,in which the push-pull converter is consider to be the main circuit.
根据实际设计指标确定系统结构,推导主要元件的参数计算并进行元件的选型,设计出一个以推挽式变换器为主电路的开关电源,并通过实验验证各项指标均已达到设计要求。
补充资料:变换器式功率因数表(见变换器式电表)


变换器式功率因数表(见变换器式电表)
transducer type power factor meter

b lanhuonq一sh一gongl口y一nshub(ao变换器式功率因数表(transdueer type powerfaetor meter)见变换器式电表。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条