1) Heat generation rate
生热量
2) heat build-up
生热
1.
The results showed that the compression heat build-up of tread decreased remarkably by combining silica 175GR and carbon black with a proper blending ratio,and at the same time,the tear resistance and rebound resilience improved significantly,the tensile strength and elongation at break increased,while the flex crack resistance was also improved slightly.
回归分析试验结果表明,白炭黑175GR与炭黑采用适当的比例并用,可使胎面胶压缩生热明显降低,抗撕裂性能和弹性显著提高,拉伸强度和拉断伸长率有所提高,抗屈挠龟裂性能有所改善。
2.
The results showed that NR/JSR T5800 could fulfill the requirement of the tire compounds and at the same time the heat build-up of the compounds was the least,the wet traction of the NR/JSR T5800 compounds was the best,while the rolling resistance was the least.
结果表明,NR/JSR T5800并用胶在满足轮胎基本物性下,其压缩生热最小、抗湿滑性最好、滚动阻力最小,能够有效地解决轮胎胎面胶滚动阻力和抗湿滑性之间的矛盾,满足高性能轮胎发展的需要。
3.
The test results showed that,by increasing the additional level of sulfur and accelerator,the curing rate of sidewall compound increased,the modulus and the flexing resistance improved,the heat build-up decreased,and other properties changed little.
结果表明,通过适当增大硫黄和促进剂用量,胎侧胶的硫化速度加快、定伸应力和耐屈挠性能提高、生热降低,其它性能变化不大,成品轮胎的高速耐久性能显著改善。
3) heat build up
生热
1.
The test results showed that the processibility of compound improved,the modulus at 300% elongation and Shore A hardness of vulcanizate increased,the tensile set at break and Goodrich heat build up of vulcanizate decreased,the heat resistance and wear resistance of vulcanizate and the performance of finished tire improved by adding 1 5 phr of modulus promoter HMZ to truck tire tread.
试验结果表明 ,在载重轮胎胎面胶中加入 1 5份模量增强剂HMZ ,可改善胶料的加工工艺性能 ,增大硫化胶的 30 0 %定伸应力和邵尔A型硬度 ,减小扯断永久变形和固特里奇生热 ,提高耐热性、耐磨性以及轮胎成品性能。
2.
The chain structures of S SBR2305,Buna SL25 1 and E SBR1500 were analysed by FTIR,and the influences of these three SBRs on the wear resistance,heat build up,rolling resistance and wet traction of NR/SBR blend were investigated by the compression heat build up test with constant load,DMA etc.
采用傅立叶变换红外光谱 (FTIR)分析了溶聚丁苯橡胶 (S SBR)S SBR2 30 5、BunaSL2 5 1及乳聚丁苯橡胶E SBR15 0 0 3种SBR的链化学结构 ,采用定负荷压缩生热、动态力学谱 (DMA)等方法研究了 3种SBR对NR/SBR并用胶耐磨性、生热、滚动阻力及抗湿滑性的影响。
3.
The dynamic mechanical properties and heat build up of black filled rubber are predicted at different load conditions based on the concept of strain amplification.
基于应变放大因子的概念，对炭黑填充橡胶的动态力学性能和在不同外载条件下的生热性能作了分析预报。
4) dynamic heat build-up
动态生热
1.
The mechanical properties and dynamic heat build-up of the compo-(site) containing 4.
当炭黑与黏土的填充量分别为45份和2份时,复合材料的物理机械性能和动态生热与填充50份炭黑时相当。
5) heat-generating system
生热体系
6) heat generation rate
生热率
1.
The heat generation rate is increase with the temperature and the carbon black content.
借助于动态力学分析技术,对八种胶料配方的动态力学性能及生热特性进行研究,结果表明:SBR和BR是相容的,滚动阻力随炭黑含量的增加而增加,湿抓着性能随炭黑用量的增加而减小,生热率随着温度的升高而升高,随炭黑的增加而增加。
参考词条
补充资料：恶生王生入地狱
【恶生王生入地狱】
（传说）毗奈耶杂事九曰：“佛记恶生王于七日后为猛火焚烧，堕在无间大地狱中。恶生闻之，大惧怖。苦母曰：如乞索婆罗门，入舍乞求，不得物时，欲使其家生种种不吉祥事。何况沙门乔答摩所有亲族，被王诛尽，宁无深重怨恨之言耶。随其恶心为咒诅耳。王若惧，则于后园中池水内造一柱楼，王应诣彼七日居住，日满后，方可入城。王便使造楼，将诸宫人及苦母升楼住。一夜过已，苦母白王言：大王，一夜已过，余六夜过，当共入城。如是二三乃至七日。苦母言今日安稳可共入城中。时四面忽云起。诸宫人相谓曰：庄严结束，可往城中。有一女以日光珠安偃枕上自严饰。云去天晴，日光忽现，照触宝珠便火出，烧其偃枕。猛炎上腾，即烧楼阁。诸宫人等四散驰走，恶生苦母皆被火烧，身皆烂熟，俱大号叫，便堕无间大地狱中，受诸极苦。”涅槃经二十曰：“阿阇世王，复于前路闻舍婆提毗流离王乘船入海遇火而死。”琉璃王经曰：“佛言诸比丘：彼琉璃王，肆意恶逆，罪盛乃尔。却后七日，有地狱火，当烧杀之，现世作罪便现世受。大使奏谶，怪与佛同。王大恐怖，乘船入海，冀得自免。停住海中，至七日期尽，水中则有自然火出。烧船及王，一时灰灭。”楞严经八曰：“琉璃大王，善星比丘，琉璃为诛瞿昙族姓。善星妄说一切法空，生身陷入阿鼻地狱。”
（传说）毗奈耶杂事九曰：“佛记恶生王于七日后为猛火焚烧，堕在无间大地狱中。恶生闻之，大惧怖。苦母曰：如乞索婆罗门，入舍乞求，不得物时，欲使其家生种种不吉祥事。何况沙门乔答摩所有亲族，被王诛尽，宁无深重怨恨之言耶。随其恶心为咒诅耳。王若惧，则于后园中池水内造一柱楼，王应诣彼七日居住，日满后，方可入城。王便使造楼，将诸宫人及苦母升楼住。一夜过已，苦母白王言：大王，一夜已过，余六夜过，当共入城。如是二三乃至七日。苦母言今日安稳可共入城中。时四面忽云起。诸宫人相谓曰：庄严结束，可往城中。有一女以日光珠安偃枕上自严饰。云去天晴，日光忽现，照触宝珠便火出，烧其偃枕。猛炎上腾，即烧楼阁。诸宫人等四散驰走，恶生苦母皆被火烧，身皆烂熟，俱大号叫，便堕无间大地狱中，受诸极苦。”涅槃经二十曰：“阿阇世王，复于前路闻舍婆提毗流离王乘船入海遇火而死。”琉璃王经曰：“佛言诸比丘：彼琉璃王，肆意恶逆，罪盛乃尔。却后七日，有地狱火，当烧杀之，现世作罪便现世受。大使奏谶，怪与佛同。王大恐怖，乘船入海，冀得自免。停住海中，至七日期尽，水中则有自然火出。烧船及王，一时灰灭。”楞严经八曰：“琉璃大王，善星比丘，琉璃为诛瞿昙族姓。善星妄说一切法空，生身陷入阿鼻地狱。”
说明：补充资料仅用于学习参考，请勿用于其它任何用途。