说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 小河超单元
1)  Xiaohe ultra-unit
小河超单元
1.
Both these two units are merged into Xiaohe ultra-unit from the structural evolution.
采用岩石谱系单位的划分原则,依结构演化序列将小河岩体划分为甘沟、后沟两个单元,归并为小河超单元
2)  ultra-unit of Yan Jiahe
颜家河超单元
3)  unit-superunit
单元-超单元
1.
Basing on the study about the unit-superunits of granites, the authors divide the member of Laiyuan-Badaling batholith, discuss the main characteristics of the unit-superunits, and point out that this member of .
本文从花岗岩类单元-起单元入手,对涞源-八达岭岩基段进行了划分,探讨了单元-超单元的主要特征,指出本岩基段是在太平洋板块俯冲机制下走滑造山作用的结果,岩浆来源于下地壳未经地表地质作用的深变质火山岩的部分熔融,并有地幔衍生岩浆的混合。
4)  unit reach
单元河段
1.
The Main stream and tributaries above Cuntan Station were separated into many reaches according to the spread time of flow,and every reach is separated into many unit reaches.
按照河段流量传播时间将寸滩以上干、支流划分为若干子河段,各子河段按照计算时段长分成若干单元河段,各单元河段区间降雨径流预报采用水箱模型,河道流量演算采用连续马斯京根法。
2.
The main stream and tributaries above the inflow reservoir station Cuntan were divided into several sub-reaches according to the propagation time of flow,and the sub-reaches were divided into unit reaches according to the calculation time interval.
按照河段流量传播时间将入库站(寸滩)以上干、支流划分为若干子河段,各子河段按照计算时段长分成若干单元河段,各单元河段区间降雨径流预报采用水箱模型,河道流量演算采用连续马斯京根法。
5)  extreme thin element
超薄单元
1.
A new method in which an array of extreme thin elements is used to cope with singular point is presented, calculation program is simplified and a good result is rapidly reached.
并提出用超薄单元近似处理奇异点的办法,使计算编程简化,能迅速地得到较好的
6)  Superelement
超单元
1.
A Study of the Key Problem in the Application of Superelement
超单元应用中的关键问题研究
2.
The finite element method was applied to model the complex suspension chassis and the component mode synthesis superelement theory was applied to reduce the dimension of the chassis dynamic model.
建立了复杂悬浮架有限元模型,利用模态综合动力凝聚超单元方法生成较低维数的悬浮架动力学模型。
3.
Every min closed region is regarded as a superelement and every superelement is changed into a ruled square under the local coordinate system by double linear interpolation.
本文提出了用矢量点乘及叉乘搜索极小封闭区域的算法,把每个极小封闭区域作为一个超单元,采用双线性插值方法,把每个超单元转化为局部坐标系下的规则正方形,按等分的方法对正方形进行网格的自动划分,同时记录局部坐标系下的结点及单元信息,然后又采用双线性插值的方法,把局部坐标系下的单元及结点信息转化为整体坐标系下的信息。
补充资料:超超
1.谓超然出尘。 2.高高在上貌。 3.犹绰绰。 4.见"超超玄箸"。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条