1) shock-induced melting region
冲击熔化区
1.
The material strength in shock-induced melting region was analyzed with renormalization group theory,and it indicates that the material strength begin to decrease as soon as the melting mass fraction reaches 0.
采用重整化理论对材料在冲击熔化区的强度进行了分析,结果表明,在冲击熔化区内,材料的强度在熔化质量分数达到0。
2) shock melting
冲击熔化
1.
The results indicate that the shock melting of the porous iron occurs in the pressure range of 121 to 157GPa.
研究结果表明 ,该多孔铁材料的冲击熔化压力范围在 12 2～ 157GPa之间 ,利用多孔铁可以测得铁在 2 0 0GPa压力内的冲击熔化温度。
2.
In this paper,we make use of the experimental results of shock melting of Al,Cu,Pb and take account of the transition of Grüneisen coefficients γ(ρ) from solid state value to liquid state value,and thus provide the scaling of melting curve T m( ρ .
利用Al、Cu、Pb的冲击熔化实验结果 ,并考虑到材料的Gr櫣ｎｅｉｓｅｎ系数γ(ρ)从固态值向液态值过渡 ,通过Lindemann熔化定律标定了熔化曲线Tm(ρ)。
3) shock induced melting point
冲击熔化点
4) release melting
冲击卸载熔化
5) impulse fuse
冲击熔丝
6) electro-bombardment zone melting
电子轰击区域熔化<冶>
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条