说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 锐角开沟器
1)  acute angle opener
锐角开沟器
1.
The acute angle opener which was specially designed can fertilize and sow at the same time, the fertilizer and seed were separated by 50mm thickness soil.
该机采用联合作业方式,开沟器为自行开发的锐角开沟器,先施肥、后下种,种肥垂直距离50mm左右。
2)  Sharp-angled opener
尖角开沟器
3)  Tine opener
尖角型开沟器
4)  furrow opener
开沟器
1.
Effect of three furrow openers for no-till wheat seeder on crop growth performance;
小麦免耕播种机开沟器对作物生长的试验研究
2.
At present,domestic and foreign exempts ploughs the seeder furrow opener type many,but the performance and the actual production request have the quite big disparity,displays the adaption crops solely,passing energy balance,broken stubble ability weak,is bigger to the surface destruction rate,adjustment difficulty,use reliability and compatible more inferior question.
目前,国内外免耕播种机开沟器种类较多,但性能与实际生产要求存在着相当大的差距,表现出适应作物单一、通过性能差、破茬能力弱、对地表破坏率较大、调节困难、使用可靠性及适应性较差等问题。
3.
The soil load characteristics of the furrow opener of no tillage planter were measured in the soil bin.
分析了免耕播种机单体的受力 ,在土槽上对四杆悬挂机构的免耕播种机单体的工作性能进行了试验研究 ,建立了开沟器牵引阻力和入土阻力回归的数学模型。
5)  Drill Opener
开沟器
1.
Analysis and Research on the Drill Opener of No-tillage Planter;
免耕播种机开沟器的分析与研究
2.
The model of horizontal distance between the front(or back)point of drill opener and metering device axle and the model of length parameters of the drill opener were set up.
利用运动学方法 ,建立了无输种管式精量播种机零速投种的数学模型 ,分析了实现零速投种的条件 ;建立了种子下落过程中位移、速度的数学模型 ,开沟器底刃端点与排种器轴心水平距离的数学模型 ,以及开沟器长度的参数计算模型。
6)  opener [英]['əʊpnə(r)]  [美]['opənɚ]
开沟器
1.
Study on dynamic vibration models of disc opener of the planter;
圆盘开沟器动力学振动模型的研究
2.
As the acute angle styled opener often tends to hang the roots and jam during direct seeding in the corn field with big roots, we adopt a new way which uses the stagger double-disk opener.
针对在玉米根茬较大,田地免耕直播时锐角式开沟器易出现挂茬、堵塞等问题,提出了采用错开双圆盘开沟器的方案。
3.
The soil load characteristics of the no-tillage planter opener were measured in the soil bin.
在土槽上对免耕播种机单体开沟器空间受力特征测定分析表明:在土壤硬度为16~26kg/cm ̄2范围内,开沟器入土阻力为70~100kg,牵引阻力为45~80kg;随工作速度和附加配重的增加,入土阻力和牵引阻力均增大。
补充资料:锐角
见“角④”(1205页)。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条