说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 排油腔
1)  discharge chamber
排油腔
1.
Using three-dimensional analysis technique,the numerical simulation and visualization of the flow field in axial piston pump discharge chamber was investigated.
运用三维流体分析技术,对轴向柱塞泵排油腔的流场进行数值模拟和可视化研究,定性分析排油腔与减振槽在不同角度接触时的模型在一定转速下速度场及压力场之间的关系。
2)  compression chamber, displacement chamber
排油腔(液)
3)  oil cavity
油腔
4)  venting of mould cavity
型腔排气
1.
By improving pouring system to enlarge the effective section for molten iron running into bottom location to speed up the molten iron reaching the bottom location,increase volume of the molten iron simultaneously reaching bottom location,enhance temperature of the molten iron reaching bottom location,and by improving venting of mould cavity,the blow hole.
阀压盖顶部和底部连接处壁薄,壁薄部位长,底部气孔缺陷多,改进浇注系统,增大铁液到达底部的有效通道,提高铁液到达底部的速度,增加同时到达底部的铁液量,提高到达底部铁液的温度,加强型腔排气,克服了气孔缺陷,获得致密、合格的阀压盖铸件。
5)  cell excluding
胞腔排除
1.
Optimal scheduling of water-supply pumping stations based on cell excluding double population genetic algorithm;
基于胞腔排除双种群遗传算法的泵站优化调度
6)  exhaust chamber
排气腔
1.
1μm between profile of sliding vane and exhaust chamber in design conditions,and the combination properties of friction and leakage are optimal when one side gap length of sliding vane and sliding vane slot is 6μm.
利用弹性力学理论和有限元法,对本实验室开发的CO_2跨临界循环第三代滚动活塞膨胀机进行了分析,结果表明:设计工况下,滑板侧面与排气腔接触处的最大变形量为1。
补充资料:排腔
1.说三道四。 2.犹陈腔。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条