1) superposed partition wall
叠合式中墙
1.
Xiaoyangshan tunnel is the first double-arched tunnel with superposed partition wall("Superposed partition wall" is used in the paper to distinguish from the composite partition wall specified in "Design Specification for Highway Tunnel") in China.
小洋山隧道在国内首先使用了叠合式中墙(为避免与设计规范复合式中墙相混淆)双连拱隧道结构形式。
2) superimposed slab shear wall
叠合板式剪力墙
1.
Considering the influence of bending,axial and shear deformation of the superimposed slab shear wall (SSSW) section to the element dynamic property,fiber model was adopted to simulate the nonlinear hysteretic property for the interaction of bending deformation and axial deformation,and shear spring model was used to simulate the shear deformation.
考虑叠合板式剪力墙(SSSW)墙体截面弯曲变形、轴向变形及剪切变形对单元动力特性的影响,应用纤维模型模拟墙体弯曲与轴向变形相互作用的非线性滞回特性,通过剪切弹簧模型对剪切变形进行模拟。
2.
The seismic damage model for four superimposed slab shear walls with edge restriction measures of two different forms and two general shear walls is analyzed.
文章基于小波变换原理,提出了一个基于小波变换的损伤指标计算模型,并用此指标对4个2种不同边缘约束措施的叠合板式剪力墙和2个普通剪力墙模型的破损进行了分析,计算结果与低周反复荷载下的试验结果吻合良好。
3) Composite center wall
复合式中墙
4) crib wall
叠墙;框格式墙
6) the superimposed slab shear walls
叠合剪力墙
补充资料：叠合式模具
分子式：
CAS号：
性质：又称叠层模。本模具的型腔在二个分型面上，前后各一。与常规模具相比它的体积约大15％，产量可提高约80％。它能充分利用注塑机的锁模力，但对模具的维修要求较高。大批量生产扁平塑料件时用它可提高生产率，降低成本。
CAS号：
性质：又称叠层模。本模具的型腔在二个分型面上，前后各一。与常规模具相比它的体积约大15％，产量可提高约80％。它能充分利用注塑机的锁模力，但对模具的维修要求较高。大批量生产扁平塑料件时用它可提高生产率，降低成本。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条