1) load-torque observation
负载力矩观测
2) load torque observer
负载转矩观测器
1.
Design and simulation of load torque observer in asynchronous motor system;
异步电动机系统负载转矩观测器的设计及仿真
2.
A neural-network-based synthetical load torque observer is designed, and the synthetical load torque is considered as measurable disturbance.
由递归神经网络构成综合负载转矩观测器 ,从而把综合负载转矩视为可测干扰 ,并利用极点配置自校正前馈控制策略实现了永磁同步电机的速度控制 ,解决了永磁同步电机系统中参数变化和负载扰动等不确定性问题。
3.
Based on this, the reduced-order load torque observer and rotor magnet chain o.
并在此基础上设计了降维负载转矩观测器和转子磁链观测器,以实时观测负载转矩扰动和电机参数的变化。
3) load thrust observer
负载推力观测器
1.
A novel sliding-mode control is designed with a load thrust observer for the Linear Permanent Magnetism Synchronous Motors(LPMSM),in order to compensate the disturbance and effectively minimize the system chattering;introducing an integral action in the sliding mode to eliminate the system error and chattering.
针对永磁同步直线电机提出了一种基于负载推力观测器的新型滑模变结构控制,从而实现对推力扰动的补偿,且大大削弱了推力纹波及系统的抖振;在滑动模态中引入积分环节来进一步消除系统的稳态误差和系统抖振。
2.
The chattering of the VSC system is effectively minimised by designing a load thrust observer and a disturbance feed forward compensation.
负载推力观测器和扰动前馈补偿的设计有效地削弱了变结构控制产生的抖振。
4) load torque
负载力矩
1.
motor speed control system with a load torque compensation is presented in this paper.
提出一种带负载力矩干扰补偿的直流调速系统。
2.
According to calculating load torque,load inertia and acceleration torque,considering the related parameters of all series servo motor of FANUC,the paper explains the particular process of AC servo motor selection with a true case.
通过计算负载力矩、负载惯量和加速力矩等要素,结合FANUC各伺服电机的相关参数,并以实例说明进给轴应选择的伺服电机型号。
3.
The load torque which is an important parameter in the model is predicted by the soft measure method.
通过对驱动斜轧穿孔机狄塞尔导盘液压系统的分析,推导出了导盘转速控制模型用软测量方法对模型中的负载力矩进行了预测,并利用前馈控制算法来抵消系统的负载力矩扰动。
5) load moment
负载力矩
1.
The main methods to decrease load moment were analyzed,and some valuable data of practice were provided.
利用雷达天线转台的典型设计实例,对作用在天线转台上的风力矩、惯性力矩和摩擦力矩进行了计算,对减小负载力矩的主要方法作了分析,提供了一些有实用价值的数据。
2.
To investigate the hydraulic performance of hydraulic turbine in pipeline,the RNG k-εturbulent model was applied to numerical simulation on the tridimensional turbulent flow in whole flow passage of pipeline hydraulic turbine under four different load moment.
为考察管路液力涡轮的水力特性,采用修正k-ε模型对四种负载力矩条件下的管路液力涡轮进行全流道三维湍流数值模拟。
6) the reduced-order load torque observer
降维负载转矩观测器
补充资料：纯轧力矩(见轧制力矩)
纯轧力矩(见轧制力矩)
net rolling torque
ehunzha iiju纯轧力矩(net rolling torque)见轧制力矩。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条