1) switching angle
开关角度
1.
Solution to switching angles for selective harmonic elimination inverter;
特定消谐逆变器开关角度的复形调优解法
2) Angle Snap Toggle
角度捕捉开关
3) switching angle
开关角
1.
In this paper, the means of harmonics control by selecting switching angles are analyzed for improving quality of output voltage in cascaded multilevel inverter.
为改善级联型多电平逆变器输出电压波形质量,对通过控制逆变单元开关角实现级联多电平逆变器谐波控制的方法进行了分析研究。
2.
In order to eliminate lower order harmonic in the multilevel inverter with equal or unequal DC source, the range of switching angles and fundamental voltage amplitude were given.
通过求解器件开关角方程,给出了模块电源电压比值不同时开关角的选择范围及输出电压基波幅值的调节范围,并依据输出电压谐波畸变率与基波幅值关系,总结了模块电源电压比值的选择原则。
3.
A kind of selective harmonic elimination inverter is designed and the number of its switching angles in every period is varied with output frequency.
设计了一种特定消谐式变频器,其每周期的开关角个数随输出频率而改变。
4) switch angle
开关角
1.
Study of widening switch angles in selective harmonic elimination inverter;
特定消谐技术中展宽开关角对的研究
2.
The nature characteristic of optimum switch angle strategy of SRM is derived from the energy conversion of SRM.
从能量转换的观点出发,利用模糊神经网络进行开关磁阻电动机(SRM)的非线性建模,得到了SRM开关角度最优控制规律。
3.
In the structure,the(equal) integration area method was used to determine the control switch angle,and the sinusoidal voltage wave was obtained by means of the concatenate superposition.
该结构利用积分面积相等的原则确定开关角,通过串级叠加的方法得到标准正弦波输出。
5) couple of switch angles
开关角对
1.
According to the requirement of on-off time of power device, this paper proposes an optimization strategy by combining the narrow pulse of widening couple of switch angles and omitting couple of switch angles.
根据功率器件开关延迟时间的具体要求,提出了展宽开关角对和省略开关角对相结合的窄脉冲优化策略。
6) horn type switch
角形开关
补充资料：Anglelapping角度研磨
angle lapping 的目的是为了测量junction的深度，所作的芯片前处理，这种采用光线干涉测量的方法就称之angle lapping。公式为xj=λ/2 nf即junction深度等于入射光波长的一半与干涉条纹数之乘积。但渐渐的随着vlsi组件的缩小，准确度及精密度都无法因应。如srp(spreading resistance prqbing)也是应用angle lapping的方法作前处理，采用的方法是以表面植入浓度与阻值的对应关系求出junction的深度，精确度远超过入射光干涉法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条