1) compounding anti-push rigidity
组合抗推刚度
2) anti-pushing rigidity
抗推刚度
1.
This paper reveals that the apportioning horizontal forces of the piers and abutments are directly proportional to the anti-pushing rigidity of their corresponding compounding pier and abutment.
本文揭示各墩台所分摊的水平力与组合墩台①抗推刚度大小成正比。
3) Flexural stiffness of composite section
组合截面的抗弯刚度
4) composite sectional bending rigidity
组合截面抗弯刚度
1.
In this paper,besed on considering the CFST as a composite material,it is the first time to theoretically analyze the CFST composite sectional bending rigidity and compare with the rigidity devived from the oringinal section dimension Using the results,this paper analyzes the high-rise frame structure of CFST preliminaril
把钢管混凝土当作一种组合材料，对钢管混凝土柱的组合截面抗弯刚度进行了理论上和试验上的研究，并与原截面尺寸计算得到的刚度值进行了比较，在此基础上对钢管混凝土高层框架结构进行了初步分析。
5) assembled stiffness
组合刚度
1.
However,there is not much research about its failure mode and assembled stiffness.
将复合梁的刚度变化划分为两个阶段,提出了分阶段的特征组合刚度计算方法。
6) composite stiffness
组合刚度
1.
Load-carrying Capacity and Composite Stiffness Investigation for Steel-concrete-filled Steel Tube;
钢骨—钢管混凝土轴压短柱承载力和组合刚度研究
2.
Based on the results of piledriving and optimal analysis, the rational matching of composite stiffness of disc~spring cap andstiffness of pile has been obtained.
本文研究了碟簧桩帽的不同组合刚度与沉桩贯人度和桩身动应力的关系。
补充资料：抗挠刚度
分子式：
CAS号：
性质：纸或纸板抵抗弯曲的强度性能。挺度与EI/W值成正比，其中W、E和I分别为纸或纸板的质量、弹性模量和惯性矩。纸板的挺度或称抗挠刚度，是指在距夹具5cm处对垂直夹着的试样施加一定负荷，观察从试样中心线弯曲3.81mm宽度，试样至15°所需的弯矩，以g·cm表示。对箱板纸和白板纸来说，挺度是一项基本性能指标。
CAS号：
性质：纸或纸板抵抗弯曲的强度性能。挺度与EI/W值成正比，其中W、E和I分别为纸或纸板的质量、弹性模量和惯性矩。纸板的挺度或称抗挠刚度，是指在距夹具5cm处对垂直夹着的试样施加一定负荷，观察从试样中心线弯曲3.81mm宽度，试样至15°所需的弯矩，以g·cm表示。对箱板纸和白板纸来说，挺度是一项基本性能指标。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条