1) water consumption
耗损水量
2) consumption
耗损
1.
Measures to lower consumption of catalytic agents in catalytic cracking;
降低催化裂化催化剂耗损的措施
2.
On the basis of the production reality of special steel,the main factors of roller consumption are analyzed At the same time the ways and methods of how to reduce the consumption of the roller are discussed in following aspectsjthe choice of the roller material;the improvement of the working condition of roller;and the management of the roller,etc.
根据特殊生产实际 ,分析了轧辊耗损的主要因素 ,从轧辊选材、改善轧辊工作条件、轧辊管理等方面探讨了冶金轧辊降耗的对策与途径。
3) dielectric dissipation
介质耗损
4) ozone depletion
臭氧耗损
1.
The remediation of ozone depletion by chemical and physical method is reviewed.
评述了修复大气臭氧耗损的化学法和物理法。
5) energy loss
能耗损失
1.
In this paper,energy loss and problems about copper line annealing process are analysed.
分析了现有铜线退火工艺的能耗损失及质量问题 ,研制开发了新型水封式铜线退火炉 ,彻底改变了传统的传热结构 ,明显提高了传热效率和退火质量。
6) energy consumption
能量耗损
1.
Researches on energy consumption mechanism and energysaving principles of hydrocyclones.Ⅰ.Theoretical Analysis of Energy Consumption;
水力旋流器能耗机制与节能原理研究Ⅰ.能量耗损理论分析
2.
The turbulence structure control by adding component parts similar to the large eddy break up device and riblets in the hydrocyclone was investigated by studying the characteristics of the turbulent pressure field,and the relationship between turbulence structure variation and energy consumption reduction was also studied.
本文将采用设置类似大涡破碎器和流向棱纹面的方法，对旋流器内的湍流结构进行控制，并研究其湍流结构的变化与能量耗损降低的关系。
参考词条
补充资料：饱和持水量测定
饱和持水量测定
measurement of saturation moisture capacity
匕aohe ehishuiliang eeding饱和持水t测定(measurement of satu-ration moisture eaPaeity)土壤农业水文特性测定项目之一，是测定土壤孔隙完全充满水时的l几壤湿度。饱和持水t所占容积等于土壤总孔隙度，可用来鉴定土壤水分饱和程度和总孔隙度。 测定方法是浸水饱和法。即在欲测地段上，用容重环刀取原状土，取土方法与测定卜壤容重时取_L相同(见土壤容l测定)。把装有未遭破坏土样的环刀称重后，使其有孔底一端(内垫滤纸)朝下，放在盛水的平底磁盘中或充满水的砂层上，使盘内水面与环刀上缘保持一样高，切勿使水面淹没环刀，以免影响空气自土壤孔隙排出，使水不能充满孔隙。经过一定时间后(砂土4一8小时，粘土8一12小时)迅速取出，用盒盖托住称重。然后再放入盘中，继续使水充满孔隙，直至前后两次重量无显著差异为止。为了计算环刀中土体的干土重，必须在同一土层上，另取土样，用称重烘干法测其湿度。用下式计算饱和持水量(占干土重的百分数): 环刀中上样吸水饱和*、、、。_后的含水量吧刊’寸小里一环万币王释的不干甭入川U.式中上样干土重(克)=环刀中的湿土重(克)xl()0100十上样湿度的百分数 此外，通过下式也可计算饱和持水量(占干土重的百分数):饱和持水量二总孔隙度 容重火10()%式中总孔隙度二1一宣重比重(林家栋)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。