1) thermal plant unit
![点击朗读](/dictall/images/read.gif)
火电厂单元机组
1.
Big thermal plant unit is a more complex controlled device with great delay,uncertainty,especially,the great delay and big inertia of boiler,which makes the conventional PID controller cannot achieve satisfying control result.
把广义预测控制方法应用于火电厂单元机组的协调控制系统中。
2) plant unit
![点击朗读](/dictall/images/read.gif)
机组;电厂单元机组
3) thermal power unit
![点击朗读](/dictall/images/read.gif)
火电单元机组
1.
A study method on load modeling of a thermal power unit by a kind of multi-input and multi-output continual WNN(wavelet neural networks) model is presented.
火电单元机组是一个复杂的多变量对象,采用常规方法难以建立它的非线性数学模型。
2.
Thermal power unit is a complex object with multi-variables.
![点击朗读](/dictall/images/read.gif)
火电单元机组是一种复杂的多变量对象,常规方法难以建立它的非线性数学模型。
3.
Large-scale thermal power unit is a system which is multi-variable,strong-coupling,time-variant with long-time delay and nonlinear,so it is hard to make system gain optimum running state with conventional control strategy.
大型火电单元机组是一个多变量、强耦合、大时滞的非线性系统,用传统的控制方法很难得到最佳的运行效果。
4) power unit
![点击朗读](/dictall/images/read.gif)
火电单元机组
1.
Coordinative control of multiobjective optimal in power unit based ongenetic algorithm;
![点击朗读](/dictall/images/read.gif)
基于遗传算法的火电单元机组多目标优化协调控制
2.
It is difficult to set up the exactly mathematic model and it is a challenge for the design of the power unit control system.
火电单元机组是一个多变量、强耦合、大时滞复杂的非线性系统,难以建立精确的数学模型,其控制系统的设计面临着严峻的挑战。
5) power plant unit
![点击朗读](/dictall/images/read.gif)
火电厂机组
1.
It is necessary to reconstruct the original power plant units through using advanced technique and devices.
DCS以其自身的特点在火电厂机组中一直保持着最广泛而可靠的应用。
6) larger thermal power air-cooling units
![点击朗读](/dictall/images/read.gif)
大型火电厂空冷机组
补充资料:贝尔哈托夫火电厂
贝尔哈托夫火电厂
Belchatow Thermal Power Plant
贝尔哈托夫火电厂(Belehatow ThermalPOwer Plant)世界最大燃煤电厂(燃用褐煤)。位于波兰中部罗兹西南贝尔哈托夫矿区,离露天褐煤矿7km,因而,也是世界最大矿口电厂。总装机容量4 320MW。1979年始建,1982年第1台机组投运,至1988年12台机组全部并网运行。电厂年平均设备利用小时为6780,年均发电量27.7TW·h。电厂供电煤耗率为3519/kw·h,厂用电率 5.4%。该电厂以220kV及4O0kV输电线路向罗兹、华沙、克拉科夫等地区送电,还在建设向波兹南输电的线路。 主要设备电厂安装12台36OMW亚临界压力的机组。锅炉最大蒸发量为1 15Ot/h,其新蒸气压力为17okgf/emZ(Ikgf=9.80665N,下同),过热及再热蒸气温度为570/550C。锅炉主要燃料为当地褐煤,由于当地褐煤的热值不稳定,短期平均热值为1600kcal/kg(zkeal一4 z86.8),下同),当其热值低于1100keal/kg时则需投油稳定燃烧,故以油作为辅助燃料。锅炉设计采用欧洲技术,波兰自行制造。汽轮机为单轴、四缸(高、中压缸各1个,双流低压缸2个)、四排汽口。蒸气参数为i6skg王/emZ、560/540℃,转速3 ooorpm,其额定出力36oMw。发电机采用全氢冷方式,其额定出力为42,6MVA,功率因数为。.85,电压22kV,采用可控硅励磁系统。燃料系统电厂所用褐煤由露天煤矿经3条长皮带输送机运送到电厂储煤场。皮带宽225omm,皮带速度5.24m/。,煤粒度。~30omm,每台皮带输送机的输送能力为640Ot/h。储煤场容量约80万to煤由储煤场经输煤栈桥运至锅炉间的煤仓,每台锅炉的煤仓容量为3200t。煤在锅炉间经锤式碎煤机破碎到。一弓mm粒度后,进人风扇磨制粉,同时采用热风干燥。 烟气净化及除灰系统锅炉烟气除尘采用静电除尘器,其除尘效率为99·6%。为使排烟脱硫,现已在4台锅炉后安装了湿式脱硫装置,其余锅炉将陆续安装。净化后的烟气通过高300m的多管烟囱排入大气。12台锅炉共建有6座多管组合式烟囱,其外筒为钢筋混凝土结构,其内部烟管为钢结构。锅炉的灰渣采用水力冲灰系统排除。灰渣从锅炉排出后由高压水冲人灰池,然后经灰浆泵及输灰管道送往灰场。储灰场的容量为4000m3。储灰场的灰大部分用于回填露天矿的采坑。 供水系统电厂的水源主要来自露天矿区的清水井,所供井水占总清水量的95%;其次是来自矿区工业和生活用水经处理后的净化水。电厂采用闭式循环冷却系统,汽轮机的循环冷却水经该系统中的冷却塔冷却后循环使用。「(王瑞梁)
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条