1) thermal sleeve
热套筒
1.
The calculating result shows that when designing hollow axis,the effects of thermal sleeve should be considered.
根据接触非线性理论,利用有限元软件ANSYS对推进电机空心轴与过盈套筒之间的接触作用进行了模拟计算,分析结果得出在设计计算中应考虑热套筒作用的结论,同时计算结果为空心轴的设计以及转子结构设计提供了理论依据。
2) heating muff
加热套筒
3) shrinkage
热套
1.
This paper describes the rotor rim shrinkage experience of unit 11# rotor in Three-gorge left plant and on the basis make an improvement for assembling the unit 12# rotor.
本文总结三峡电站左岸11#机转子热套经验,对12#机转子热套工艺进行改进,使热套加热升温时间由原来60h降为40h,热套后转子磁轭圆度等主要技术指标达到优良标准。
4) heat insulation sleeve
隔热套
1.
The new technologies adopted in the design of φ1830mm 25 0mm dryer bearing assembly such as cone journal, CARB bearing, heat insulation sleeve and oil lubrication are introduced and the principle of lowering bearing temperature is discussed.
介绍在φ1830mm×6250mm烘缸轴承装置设计中采用的新技术,如锥颈轴、CARB轴承、隔热套、稀油润滑,同时探讨了降低轴承温度的原理。
5) Shrink Fit Technology
热套工艺
1.
Shrink Fit Technology of the Casing Fin Tubes;
套片式翅片管的热套工艺
6) Electric heating-jacket
电热套
参考词条
补充资料：老套筒
1.一种旧式的步枪。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。