1) low resistance module
低电阻模块
1.
Based on analyzing the conception of low resistance grounding module,low resistance module and traditional grounding material were compared and analyzed from site area,corrosion and life problem,pollution problem and cost expense,and the advantage of low resistance grounding module was summarized,so as to proof the practicality of this grounding material.
在简析低电阻接地模块概念的基础上,从占地面积、腐蚀和寿命问题、污染问题、成本费用等方面将低电阻模块与传统接地材料进行了对比分析,并总结出低电阻接地模块的优点,从而证明了该接地材料的实用性。
2) low resistance earthing module
低电阻接地模块
3) modular resistance
模块电阻
4) RTD Module
热电阻模块
1.
Treatrnent of the Abnormal Measurement Value of Quantum PLC RTD Module;
Quantum PLC热电阻模块测量异常处理一例
5) resistor transistor module
电阻晶体管模块
6) sheet resistance
方块电阻
1.
Kinetics of the oxidation process of the copper films in the thickness range of 16～22 nm at 140 ℃ was studied by using transmission spectrum and sheet resistance methods.
采用方块电阻和透射光谱两种方法为表征手段,测量16～22nm范围内不同厚度Cu薄膜在140℃下完全氧化所需要的时间,得到了Cu薄膜氧化反应的动力学曲线,并利用X射线衍射(XRD)分析了氧化产物的晶相结构和成分。
2.
The sheet resistances and reflectivity of ultra-thin aluminum and nickel films were measured when they were applied to foam with different thickness.
测量了Al,Ni薄膜的方块电阻及其用于不同厚度泡沫结构的平板反射率,实验结果表明:超薄金属膜结构可以实现谐振吸收;吸波性能由介质材料和金属薄膜共同决定。
3.
Then,the effects of heat treatment and temperature on the chemical composition and sheet resistance of the prepared films were investigated by XRD,EDXS and sheet resistance measurements.
利用X射线衍射和能量散射X射线能谱表征方法,并结合薄膜方块电阻的测定,探讨了热处理方式和热处理温度对薄膜化学组成及薄膜电阻的影响。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条