1) strong-loop
强循环
1.
The features of strong-loop, weak-loop, jump and invisible tasks were analyzed, and the determinant theorems were offered, on the basis of which the γ+ algorithm was proposed with synchronized-manager models.
强循环、弱循环、跳、不可见任务等复杂结构是业务流程中常见的流程结构,从事件日志中挖掘这些复杂结构是亟待解决的问题。
2) forced circulation
强制循环
1.
Improvement of electrolyzer from forced circulation of high current density to natural circulation;
从强制循环到高电流密度自然循环电槽的改造
2.
In applying natural circulation coupled with forced circulation in the boiler circulation system, the reliability of the natural circulation loop and the safety and effectiveness of the forced circulation loop ought to be considered as well a.
对29 MW角管式热水锅炉的水动力特性进行了详细分析,并提出在应用自然循环与强制循环相结合的循环方式时,既要考虑自然循环的可靠性及强制循环的安全有效性,又要避免尾部受热面的低温腐蚀。
3.
This paper reports the analysis of both the performance characteristics of different ejectors and the hydrodynamic characteristics of the closed forced circulation system installed with different ejectors.
本文从理论上提出了计算不同结构的液体引射器特性及安装有引射器的回路强制循环流动特性的分析方法,随后使用实验方法对理论分析进行了验证,实验数据与理好计算结果符合良好,证实本文提出的分析方法正确、可靠,可应用于工程设计。
3) compulsory circulation
强制循环
1.
It also proved that a smallest circulation flux existed for corn flour suspension to fulfill compulsory circulation.
对外环 流式发酵罐用于玉米生料酒精发酵进行研究,结果表明,起始阶段,玉米粉悬浮液要在外环流式发酵罐中完成强制 回流循环,必然存在一个最小回流量Q;通过恒流泵强制发酵醪循环可以显著缓解原料沉淀造成的不利影响,有利 于发酵罐中的传质;发酵20 h,强制循环发酵液中酵母细胞出芽率较自然发酵提高84。
4) cyclic hardening
循环强化
1.
New description on cyclic hardening or cyclic softening behavior in low cycle fatigue;
材料低周疲劳中循环强化或循环软化的新描述
2.
Present experiments have shown that 1Cr18Ni9Ti was a cyclic hardening material.
对 1Cr18Ni9Ti不锈钢进行了多轴棘轮效应及典型的非比例循环试验研究 ,表明1Cr18Ni9Ti钢是循环强化材料并表现出明显的非比例循环附加强化。
3.
The plastic strain hardening is introduced into shakedown region V_s and the cyclic hardening into fatigue region V_F·The assumption that the thermal stress history is the linear elastic stress history is ignored because it differs markedly from the realistic constitutive response and brings abou.
采用较真实的材料本构模型,在Ponter和Karadeniz提出的扩展的安定性理论以及彭得到的考虑混合强化的安定性定理的基础上,发展了计及应变强化和循环强化的结构塑性安定区的分析方法。
5) cyclical pressure
循环压强
1.
This paper makes an analysis of cyclical pressure and optimum pressure freeze dryings.
对循环压强法和最佳压强法冷冻干燥作了分析,建立了一套求取其最佳参数的简易方法。
6) forced-convection
强迫循环
1.
Research of flow instability in forced-convection generator;
强迫循环下蒸汽发生器流动不稳定性研究
补充资料:强制循环蒸发器
分子式:
CAS号:
性质:在蒸发系统中装有送液泵,用泵迫使液体循环流动的蒸发装置。这种蒸发器的液体循环速度为1.2~3.5m/s。强制循环蒸发器的优点为传热系数大,抗盐析,抗结垢,易于清洗,适用性能好,缺点为动力消耗大,每平方米传热面积消耗功率为0.4~0.8kW。它可用于处理黏性、易结晶、易结垢或浓缩程度较高的溶液。
CAS号:
性质:在蒸发系统中装有送液泵,用泵迫使液体循环流动的蒸发装置。这种蒸发器的液体循环速度为1.2~3.5m/s。强制循环蒸发器的优点为传热系数大,抗盐析,抗结垢,易于清洗,适用性能好,缺点为动力消耗大,每平方米传热面积消耗功率为0.4~0.8kW。它可用于处理黏性、易结晶、易结垢或浓缩程度较高的溶液。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条