1) Static momental rigidity
静态力矩刚度
2) Static stiffness
静态刚度
1.
On the control to static stiffness of tower in tower crane;
塔式起重机静态刚度现状与分析
2.
In the static analysis, study mainly focused on the static stiffness and in obtaining the static stiffness distribution of the whole work piece table.
在静态特性中着重分析了微进给平台的静态刚度,得出整个动平台的工作平面上的刚度分布图。
3.
The Reynolds equation was solved by the finite difference method(FDM) in SOR iteration to obtain the pressure distribution in sealing clearance and the curves of leakage flowrate and static stiffness in different conditions.
为探讨浅槽环瓣型浮动环密封的性能特点,首先分析了密封的结构和工作机理,采用FDM(F in ite D ifferenceMethod)、牛顿超松弛迭代求解Reynolds方程,获得密封间隙的流场压力分布及各种工况条件对泄漏量、静态刚度的影响。
4) torque rigidity
力矩刚度
1.
The theoretical derivation and numerical analysis indicate that the reason is the torque rigidity of 0 and isolation degree of 71.
研究了角速率陀螺稳定平台在目标跟踪时瞄准线始终围绕视场中心做约2 Hz晃动的现象,理论推导及数值分析认为引起这一现象的原因与光电稳定平台的静态力矩刚度为0、隔离度仅为71。
5) Dynamic and static stiffness
动静态刚度
6) Quasi static Rigidity
准静态刚度
补充资料：纯轧力矩(见轧制力矩)
纯轧力矩(见轧制力矩)
net rolling torque
ehunzha iiju纯轧力矩(net rolling torque)见轧制力矩。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条