1) Convexity of extruding
挤出端凸度
2) delivery end
挤出端<挤塑机>
3) extrusion velocity
挤出速度
1.
Effect of extrusion velocity to wear degree of aluminum profile;
铝型材挤出速度对模具磨损程度的影响
4) extrusion temperature
挤出温度
1.
The influences of screw configuration,screw speed,extrusion temperature and water contents on extruded starch foams were studied.
研究了螺杆组合、螺杆转速、挤出温度以及含水量对淀粉挤出发泡的影响。
2.
The excellent properties of resin and fiber would be fully embodied through the proper propessing technique and conditions, extrusion temperature, extrusion rate, injection speed are the important factors influencing material property.
结果表明,适宜的加工工艺和加工条件能够将ABS和玻璃纤维本身的优良性能充分表现出来,挤出温度、挤出速度及注射速率都是影响材料性能的重要因素。
3.
The effect of main screw parameters (length/ diameter ratio, helix angle, channel depth and compression ratio)of cold feed rubber extruder on extrusion temperature were investigated by orthogonal regression method on the basis of the statistical analysis of experimental results.
研究了螺杆造型（长径比，螺旋升角，螺槽深度，螺杆几何压缩比），挤出工艺（螺杆转速，机头口型）和胶料种类对橡胶冷喂料挤出机挤出温度的影响，并对各实验因素及实验结果做了统计分析，得出了他们之间的定量数学模型。
5) institutional crowding out
制度挤出
1.
Some economists prove institutional crowding out theory in the environmental protection experiments and make challenge to the environmental policies based on standard new classic economic model which will not realize Pareto optimization because of institutional crowding out.
制度挤出现象的发现对这一预言提出了挑战,并引发了大量关于经济激励产生挤出的研究。
6) protrusion
[英][prə'tru:ʒn] [美][pro'truʒən]
凸出度
补充资料：凸凸
1.高出貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条