1) dipping time
浸锌时间
1.
Effect of dipping time on microstructure and mechanical property of galvanized steel wire is study through test.
通过试验研究浸锌时间对热镀锌钢丝微观组织、力学性能的影响,结果表明:钢丝经热镀锌后,其强度及扭转性能指标低于光面钢丝且随浸锌时间而变化,适当减少浸锌时间,可缩小镀层中脆性相的厚度,但过短的浸锌时间导致镀层不均匀、合金层开裂等问题出现,从而降低钢丝的扭转性能。
2) impregnating time
浸渍时间
1.
Influences of temperature and impregnating time on the dichloromethane impregnating experiments of PVC-U pipes;
温度和浸渍时间对PVC-U管材二氯甲烷浸渍实验的影响
3) Extraction time
浸出时间
1.
TCLP experiment has been performed to study the relationships between liquid-to-solid ratio (L/S), initial pH value, extraction time and leaching characteristics of heavy metals (Pb, Cr, Cd, Ni, Cu, Zn) in fly ash from a coal and MSW(municipal solid waste) co-firing fluidized bed incinerator.
对用流化床焚烧炉混烧垃圾和煤的布袋飞灰进行了重金属的TCLP(ToxicityCharacteristicLeachingProcedure)浸出特性实验,探讨了液固比、初始pH值及浸出时间对飞灰中重金属Pb、Cr、Cd、Ni、Cu、Zn的浸出影响。
4) soaking time
浸泡时间
1.
Effect of soaking time of Rooting Powder on emergence rate of cutting reproduction of Euodia rutaecarpa (Juss.);
速效生根灵浸泡时间对吴茱萸扦插出苗的影响
2.
The paper describes the important effects of soaking time to soybean on utilize rate of protein and quality of Tofu.
通过不同浸泡时间的大豆截面组织形态结构变化的扫描电镜观察以及制得豆腐的物性测定研究说明:原料大豆浸泡程度是影响豆腐质量的一个关键性因素,可以通过适当的浸泡时间来提高豆腐的质量。
3.
The texture characteristics and taste quality of milled rice processed under different values of water/rice ratio,soaking time and warm preservation time were studied.
对不同蒸煮条件(加水量、浸泡时间与焖制时间)下米饭的质构特性和食味品质的变化趋势进行研究,结果表明:对于所选品种,当加水量为米重的1。
5) extraction time
浸取时间
1.
The result showed that the relationship between extraction time and yield of it can be described in formula:y=xa+bx.
用石油醚浸取法 ,研究了浸取时间和粉碎处理对香紫苏花萼浸膏得率的影响。
2.
Through experiments,this paper established the best qualification of leadin phase analysis of a metal mine in Hexi region,Gansu province,including the density of selective solvent,extraction time etc.
通过实验,建立了甘肃省河西地区某金属矿中铅的物相分析的最佳条件,包括选择性溶剂浓度,浸取时间等。
6) immersion time
浸水时间
1.
This paper probes the relevant problems of gravity immersion applied in ship ballast water system, presents some typical designs of gravity immersion and the calculation method of ballast tanker immersion time.
本文对重力浸水在船舶压载水系统中应用的有关问题进行了探讨 ,给出了重力浸水设计的一些典型思路并提供压载舱重力浸水时间的计算方
2.
The CBR values of different degree of compaction,water content and immersion time are obtained through lab experiment.
采用室内试验方法,进行不同压实度、含水量和浸水时间的CBR值测定,分析了他们对黄土填料CBR值的影响规律。
补充资料：从锌浸出渣中浮选银的装置(株洲冶炼厂)
从锌浸出渣中浮选银的装置(株洲冶炼厂)
从锌浸出渣中浮选银的装置(株洲冶炼厂)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条