1) narrow gap pulse welded
窄间隙脉冲焊
2) narrow gap TIG hot wire welding
窄间隙脉冲热丝TIG焊
3) narrow gap welding
窄间隙焊
1.
Based on the experiment of twin-wire narrow gap welding in single pool mode by employing alternative pulsed arcs, the influences of welding parameters on the appearance of weld and welding process stability were investigated.
采用交替脉冲,对双丝共熔池窄间隙焊进行工艺试验,研究了焊接参数对焊缝成形和电弧稳定性的影响。
2.
Lateral oscillation arc welding, high-speed-rotating arc welding, twin-wire welding, and ultra NGW(narrow gap welding) can all assure the fusion of side wall and improve the oppearance of weld in relatively small welding variables.
横向摆动电弧、高速旋转电弧、双丝焊和超窄间隙焊4类方式都可以在较小的焊接规范下,保证侧壁熔合,改善焊缝成形,防止焊接裂纹。
3.
The hollow-axis motor drives the offset nozzle and rotates the arc on the tip of wire at high speed,so as to ensure enough penetration into the sidewalls in narrow gap welding.
在该系统中,焊丝穿过电机的空心轴后从导电嘴的偏心孔送出,电机带动导电杆和偏心导电嘴旋转,从而使焊丝端部的电弧以一定直径高速旋转,以保证窄间隙焊接接头具有足够的侧壁熔深。
4) narrow-gap welding
窄间隙焊
1.
There are many errors such as the adjusting error and the error due to the actual place behind the place measured by sensor and the error due to arc interaction and the error of optical parameter and the initial error and the error due to demarcating parameter in the narrow-gap welding Automatic following system with CCD figure treatment.
带CCD图像处理的窄间隙焊缝跟踪系统中 ,存在执行调节误差、传感导前误差、弧光干扰误差、光学参数误差、初始给定误差、标定参数误差等。
5) narrow gap welder
窄间隙焊机
6) narrow gap welding
窄间隙焊接
1.
The possibility of engineering application of technical methods of flux cored arc welding to the field of narrow gap welding is studied.
研究了药芯焊丝电弧焊（ＦＣＡＷ）工艺方法在窄间隙焊接领域中的工程应用可行性。
补充资料：胎圈过窄、子口窄、圈窄等
分子式：
CAS号：
性质：又称胎圈过窄、子口窄、圈窄等。轮胎工业中指两胎圈宽度不一致的现象。
CAS号：
性质：又称胎圈过窄、子口窄、圈窄等。轮胎工业中指两胎圈宽度不一致的现象。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条