1) SiC suspension
SiC悬浮液
1.
Influence of pH, tetramethyl ammonium hydroxide (TMAH), ionic strength and alkali treatment on the rheological properties of aqueous SiC suspensions was investigated.
研究了pH、四甲基氢氧化铵(TMAH)、离子强度及碱处理对水基SiC悬浮液流变性的影响。
2) SiC aqueous suspension
SiC水悬浮液
1.
By choosing nanoSiC as the raw material,1 vol% nanoSiC aqueous suspension is obtained by using stabilization mechanisms including single electrostatic, steric ( by PEG ) and electrosteric ( by PMAA-NH4)respectively.
选用纳米粉SiC为原料,分别采用单一静电稳定机制、加入PEG的空间位阻稳定机制和加入PMAA-NH4的电空间稳定机制,制备成1vol%的SiC水悬浮液。
2.
1vol% nano-SiC aqueous suspensions were obtained by different colloidal stabilization mechanism including singleekectrostatic, steric( by PEG ) and electrosteric( by PMAA-NH_4).
选用纳米级SiC颗粒为原料 ,分别采用单一静电稳定机制、加入PEG的空间位阻稳定机制和加入PMAA-NH4的电空间稳定机制 ,制备固相体积分数为 1vol%的SiC水悬浮液 ,通过Zeta电位、沉降实验和粘度测定及粒度分析等手段 ,最终分别获得了碱性条件下高分散、高稳定的SiC水悬浮液 。
3) suspension
[英][sə'spenʃn] [美][sə'spɛnʃən]
悬挂;悬浮;悬浮液，悬浮体
4) suspension
[英][sə'spenʃn] [美][sə'spɛnʃən]
悬浮液
1.
Research on inner suspension and its application to GIF cementing;
固井内置悬浮液研究与应用
2.
The study on the dispersion and stability of ZrO_2 nanoparticles suspension;
纳米二氧化锆悬浮液分散稳定性研究
3.
Dispersion and rheology studies for the nano alumina trihydroxide aqueous suspension;
纳米氢氧化铝的分散与水悬浮液流变研究
5) ZrO_2 suspension
ZrO2悬浮液
6) suspending liquid
悬浮液
1.
The results show that ξ potential with absorbency have the good corresponding relations,the higher absolute value of ξ potential,absorbency is bigger,then the system dispersion stability is better;The pH values,the dispersing agent type and join the quantity affects polishes the suspending liquid stable primary factor.
通过测定高铈抛光粉(以下简称抛光粉)悬浮液的ξ电位、吸光度和粘度,探讨了不同pH值、分散剂种类及浓度对抛光粉水相体系分散稳定性的影响。
2.
It has been searched by withories and practices that TiO_2 powder is dis-tributed in ethylene glycol to form suspending liquid made by premixing-grinding process.
给出采用砂磨分散工艺制备二氧化钛/乙二醇悬浮液的预分散配料比、研磨分散时间及磨砂补充操作的优化结果和值得考虑的设备改进。
3.
The characteristic of suspending liquid has been analyzed through theories and experim- ents,performance curves were measured the relation of the viscosity and temperature,and between pH value and temper- ature of slurry.
对硅片线切割工艺中悬浮液特性进行了理论与实验分析。
补充资料：混合液悬浮固体
分子式：
CAS号：
性质：活性污泥法曝气池内废水与活性污泥混合液中悬浮固体的浓度，以mg/L计。传统活性污泥法曝气池的混合液悬浮固体一般控制在2000～3500mg/L。
CAS号：
性质：活性污泥法曝气池内废水与活性污泥混合液中悬浮固体的浓度，以mg/L计。传统活性污泥法曝气池的混合液悬浮固体一般控制在2000～3500mg/L。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条