1) particles' concentration
胶粒浓度
2) Micelle-formation critical concentration-1
胶粒形成临界浓度-1
3) Solid Concentration
颗粒浓度
1.
Distribution and Calculation of the Solid Concentration in Gas-Solid Risers;
气固提升管内颗粒浓度的分布与计算
2.
Numerical calculation of axial solid concentration profiles in a high efficiency regenerator;
高效再生器内轴向颗粒浓度分布的数值计算
3.
The solid concentration of gas-solid two-phase flow in a fluid catalytic cracking riser (φ186 mm×12 m) is measured with γ-ray attenuation technology.
在实验室流化床装置上用γ射线衰减技术对φ186mm×12m提升管内的FCC催化剂颗粒浓度进行了测量。
4) particle concentration
颗粒浓度
1.
Numerical simulation on particle concentration distribution in cyclone separator;
旋风分离器内颗粒浓度场的数值模拟
2.
Effects of particle concentration and optical thickness on flame temperature field reconstruction;
颗粒浓度和光学厚度对火焰温度场重建的影响
3.
The radial profile of particle concentration under different apparent gas velocities with different internals were measured along the dire.
分别从方截面正向、斜向上的颗粒浓度分布,讨论了内构件对颗粒轴向返混、径向掺混及截面浓度的作用,分析了构件尺寸对实验结果的影响。
5) particle consistency
微粒浓度
1.
So many students are puzzled with the correct comparison between the relations of the particle consistency in electrolytic solution that correctly grasping it can help understand the knowledge of hydrolysis and electrolysis in order to improve students’ comprehensive analytic capability.
电解质溶液是中学化学的一个重要组成部分,是高考的热点,电解质溶液中微粒浓度关系的正确比较与判断,常常是很多学生学习的难点和盲点。
6) solids holdup
颗粒浓度
1.
To investigate the pressure drop due to the friction between gas-solid suspension and CFB riser wall and its effect on the measurement of average solids holdups by pressure transducers,models for predicting the pressure drop and the solids holdup were developed.
为确定气固提升管充分发展段的摩擦压降及其对颗粒浓度测试的影响,提出了充分发展段内气固两相流与管壁间摩擦压力降的计算模型,由此获得充分发展段内真实颗粒浓度的计算公式;同时在两套提升管实验装置上对压力梯度分布和局部颗粒浓度进行了系统测试和对比分析。
2.
The pressure gradients of air-sand two-phase flow in a CFB riser were systematically measured in a 10m high CFB riser to investigate the axial distributions of averaged solids holdups of coarse particles and the effects of operation conditions.
在10m高提升管中对空气-沙子体系的压力梯度进行系统测试,研究了粗重颗粒平均颗粒浓度sε的轴向分布及操作条件对它的影响。
3.
A nonlinear model for generation of solids holdup time series in the CFB riser based on combination of chaos with artificial neural network was proposed.
基于气固循环流化床是一混沌动力学系统,故采用了耦合混沌理论中的重构相空间方法与人工神经网络的非线性映射功能,建立起提取气固循环流化床颗粒浓度时间序列的非线性模型,并将此模型应用到f100mm×16m,FCC固体颗粒的上行气固循环流化床系统。
补充资料：临界胶束浓度
分子式：
CAS号：
性质：表面活性剂溶液的一种特性浓度。大于此浓度时溶解的表面活性剂分子与聚集成胶束的分子或离子有一个动态平衡。在临界胶束浓度附近的狭窄范围内，浓度与物化性能之间(如表面张力、去污力、润湿性能等)有一突然变化，表现出表面活性剂最佳表面活性。所以临界胶束浓度常用来表征表面活性剂的表面活性。
CAS号：
性质：表面活性剂溶液的一种特性浓度。大于此浓度时溶解的表面活性剂分子与聚集成胶束的分子或离子有一个动态平衡。在临界胶束浓度附近的狭窄范围内，浓度与物化性能之间(如表面张力、去污力、润湿性能等)有一突然变化，表现出表面活性剂最佳表面活性。所以临界胶束浓度常用来表征表面活性剂的表面活性。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条