1) deformation recovery rate
变形恢复率
1.
Impact of different treatments on compressed deformation recovery rate of poplar wood;
不同处理方法对杨树木材压缩变形恢复率的研究
3) displacement restoring capacity
变形恢复
1.
Based on the active-control experiments of eight piezoelectric smart beams,the strain and displacement restoring capacity and the characteristics of crack closing of smart beams,under static loads and actuating forces induced by piezoelectric actuators,are systematically studied.
基于8根压电智能混凝土梁的主动控制试验,较为系统地研究压电智能混凝土梁在静力荷载和压电驱动器产生的驱动力作用下的变形恢复能力、应变恢复特性和裂缝闭合特征,重点分析配筋率、跨高比和驱动器埋设位置等因素的影响。
4) shape recovery ratio
形状恢复率
1.
This paper studies the shape recovery ratio of the welded joints obtained by precision pulse resistance butt welding with the self designed clamp.
对TiNi形状记忆合金精密脉冲电阻对焊接头形状恢复率进行了研究。
2.
The experiment results showed that the shape recovery ratio increased as the solid solution temperature,and reached maximum at 1000℃,then decreased with further increase in the solid solution temperature.
试验结果表明,形状恢复率随着固溶处理温度的升高而提高,固溶处理温度约为1000℃时达到最大值,随后恢复率随着固溶处理温度的进一步升高而降低。
5) shape recovery rate
形状恢复率
1.
The effect of high temperature annealing treatment at 850℃ on microstructure,transformation and shape recovery rate of Ti-50.
84at%Ni合金紧箍环显微组织、相变特征和形状恢复率的影响。
6) recoverable deformation
可恢复变形
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条