1) skin-to-stiffener
加筋蒙皮
1.
In order to validate its enhancement effect comparing to traditional bond structures,two groups of stitched/non-stitched composite T-shaped and L-shaped skin-to-stiffener performs were designed,and check experiment on the strength of non-stitched/stitched skin-to-stiffener structures,loaded in tensile pull-off,was performed.
为了验证其相比于传统胶接强度的提高程度,研究设计了复合材料缝合与非缝合T型和L型加筋蒙皮试验件和试验夹具,进行了拉脱破坏强度的对比试验,结果表明缝合后的L型试件平均强度提高了93。
2) welded wire fabric
蒙皮钢筋
1.
Application of welded wire fabric to flexural members reinforced with high strength bars
蒙皮钢筋在高强钢筋混凝土受弯构件中的应用
2.
The bending capacity and crack width at service loads were analyzed,and the bending capacity,deformation and crack width of two groups of the members with welded wire fabric near the concrete surface were compared.
分析了采用500 MPa钢筋的混凝土构件的正截面受弯承载力及使用阶段的裂缝宽度,同时对其中两组配有蒙皮钢筋的梁进行受弯承载力、变形及裂缝宽度的对比分析。
3) reinforced aircraft skin
加强蒙皮
1.
Study on damage of a reinforced aircraft skin subjected to 12.7 mm projectile impact;
飞机加强蒙皮在12.7mm弹丸撞击下的变形与破坏
4) reinforced turf
加筋草皮
5) skin-to-stiffener structure
筋条-蒙皮结构
1.
The interfacial fracture process of stitched/non-stitched composite L-shaped skin-to-stiffener structures under pull-off load was simulated using self-defined suture model and Cohesive element method.
用自定义的缝线模型和Cohesive单元方法,模拟了复合材料非缝合/缝合胶接L型筋条-蒙皮结构胶接界面在拉脱载荷作用下的失效过程;分析了第一排缝线位置和筋条突缘宽度对界面强度的影响。
6) rein-forced body skin
弹体加强蒙皮
补充资料：黄皮绿筋竹
黄皮绿筋竹介绍 黄皮绿筋竹 (Phyllostachys viridis cv.Youngii) 科属:
禾本科
别名:
形态特征:
高度10（M），秆小金黄色，节下有绿色环带，节间有少数绿色纵条纹
分布与习性:
分布于长江流域地区，阳性，喜温暖湿润气候
繁殖与栽培:
暂无
应用:
庭园观赏
图片:
禾本科
别名:
形态特征:
高度10（M），秆小金黄色，节下有绿色环带，节间有少数绿色纵条纹
分布与习性:
分布于长江流域地区，阳性，喜温暖湿润气候
繁殖与栽培:
暂无
应用:
庭园观赏
图片:
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条