说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 高速离心鼓风机
1)  high-speed centrifugal blower
高速离心鼓风机
1.
Aimed at the start-up failure of high-speed centrifugal blower in a WWTP,the failure diagnosis was carried out,and the failure was eliminated successfully,ensuring the normal operation of the equipment.
针对污水处理厂的高速离心鼓风机出现启动故障的问题,进行了故障诊断,最终成功排除故障,保证了该设备的正常运行。
2)  high-temperature centrifugal blower
高温离心鼓风机
3)  high pressure centrifugal blower
高压离心鼓风机
4)  centrifugal blower
离心鼓风机
1.
With regard to the first phase project of Shaoxing Wastewater Treatment Plant(WWTP),the maintenance and reconstruction for cooling system of centrifugal blower were introduced.
介绍了绍兴污水处理厂一期工程离心鼓风机冷却系统的维护与改造情况,在实施各项改造措施后提高了鼓风机系统的运行效率,降低了鼓风机的故障率,保证了污水厂的稳定运行。
2.
High speed centrifugal blowers are key equipment in sulfuric acid production system with waste gases from zinc metallurgy.
高速离心鼓风机是冶炼烟气制酸系统的关键设备。
3.
Since centrifugal blower D900-2 5/0 97 was remaked with three dimensional,flow model,the blows raises from 900 m 3/min to 1 100 m 3/min,the exit pressure increases from 2 45×10 5 Pa to 2 94×10 5 Pa, the top efficiency advances from 78% to 82%.
对现有离心鼓风机 D90 0— 2 。
5)  centrifugal blower
离心式鼓风机
1.
Practice of increasing capacity and improving efficiency and wear behavior of centrifugal blower;
关于离心式鼓风机增容、增效及提高耐磨性的实践
2.
Also a lot of simulator experiments which take D900 centrifugal blower of a metallurgy factory as an example have been done, and the result shows that the method can be used to identify the magnitude and directi.
提出了一种辨识不平衡状态的新方法,并以某冶金厂D900离心式鼓风机为例进行了模拟实验,结果表明,该方法能辨识不平衡量在3个叶轮中分布的大小和方位。
3.
Through the test and analysis of the vibration in speed increasing box of D1500 centrifugal blower units,the reason of causing coupling damaged frequently is found out.
通过对D1500离心式鼓风机组增速箱振动的测试分析,找出了引起联轴器频繁损坏的原因,经过调整,保证了机组安全运行;同时还对引起增速机齿轮固有频率产生强烈振动的原因进行了分析。
6)  centrifugal fan
离心式鼓风机
补充资料:离心式鼓风机
分子式:
CAS号:

性质:利用离心力的作用来输送气体的鼓风机,所产生的压力是0.0147~0.196MPa(0.15~2kgf/cm2)。工作原理与离心泵相像。叶轮装在蜗形机体内。叶轮转动时,产生离心力,将气体抛至叶轮的外圆周,经排出口排出,同时还增高气体的密度。有单级和多级的区分,前者只有一个叶轮,后者有两个以上的叶轮固定在同一根轴上。广泛应用于硫酸、合成氨、硝酸等的生产中。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条