1) solid-liquid suspension
固液悬浮
1.
Standard k-ε turbulent model was used to simulate the steady liquid phase flow field, and the unsteady solid-liquid suspension process was simulated with the Eulerian multiphase model.
以数值模拟对偏心搅拌时的固液悬浮特性进行了研究,物料选用固相体积分数为15%、粒径为135μm的球形玻璃珠-水两相体系,采用标准k-ε湍流模型模拟液相流动,采用欧拉多相流模型模拟悬浮过程,分析了偏心率对搅拌流型、颗粒浓度分布及能量消耗的影响。
2.
The functions of the mixing equipment are mixing, heat transferring, solid-liquid suspension, etc.
糖化锅中的搅拌装置起混合、传热、固液悬浮等作用。
2) solid-liquid suspension
固-液悬浮
1.
Gas-liquid-buoyant particle three phase stirred tank/reactors are widely used in many industries and very few studies involve in the effect of buoyant particle characteristics on the solid-liquid suspension and gas-liquid dispersion.
8T,研究了颗粒特性及操作液位对空气-水-上浮固体三相体系的固-液悬浮及气-液分散性能的影响。
3) liquid-solid suspensions
液固悬浮液
1.
Numerical simulation of bubble formation in liquid-solid suspensions;
液固悬浮液中气泡生成的数值模拟
4) Solid suspension sampling
固体悬浮液进样
5) MLSS
混合液悬浮固体
6) mixture liquid suspended solid(MLSS)
混合液悬浮固体浓度
1.
3mg/L;mixture liquid suspended solid(MLSS) of 5200~7800 mg/ L,the reactor can effectively remove the pollutants and the average removal rate of COD ?NH3-N was 90.
3 mg/L,反应器中混合液悬浮固体浓度(MLSS)维持在5200~7800 mg/L时,MBR对水中的COD、NH4+-N平均去除率分别为90。
补充资料:混合液悬浮固体
分子式:
CAS号:
性质:活性污泥法曝气池内废水与活性污泥混合液中悬浮固体的浓度,以mg/L计。传统活性污泥法曝气池的混合液悬浮固体一般控制在2000~3500mg/L。
CAS号:
性质:活性污泥法曝气池内废水与活性污泥混合液中悬浮固体的浓度,以mg/L计。传统活性污泥法曝气池的混合液悬浮固体一般控制在2000~3500mg/L。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条