说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 比界面能
1)  Specific Interfacial Energy
比界面能
1.
Calculation of Specific Interfacial Energy and Ripening Rate for Cooper in Ferrite of Bainite Steel;
Cu在贝氏体钢铁素体中的比界面能及熟化速率计算
2)  specific interfacial area
比界面积
3)  the performance ratio bound
性能比界
1.
Its best worst-case the performance ratio bound is 1+1-1/m1+[k/m], where k>0 is an integer number and [k/m] is the largest integer number no more than k/m.
将n个工件分配到m台平行机上加工,在工件的加工不中断及目标函数是极小化最大完工时间的条件下, 对其GKK算法的最坏情形性能比界作了改进,并用实例表明了所得新上界的可达性。
4)  interfacial property
界面性能
1.
The interfacial property between PBO fiber and epoxy matrix was investigated by fiber impregnate test, NOL ring interlaminate shear test and scan electron microscopy(SEM).
通过纤维浸润试验、NOL环层间剪切试验和扫描电子显微镜 (SEM)分析 ,PBO纤维经γ_射线辐照表面改性处理前后对纤维浸润性能及纤维 /环氧树脂界面性能具有一定的影响。
2.
Surface tension of resin,surface energy of carbon fiber and the advancing contact angle of the resin/fiber had been measured,which were used to analyze interfacial property of the resin/carbon fiber in RTM and effect on the wetting about resin/fiber after spreading tackifier solution on the surface of fibers.
通过测试树脂的表面张力、碳纤维的表面能以及树脂与纤维动态接触角来分析RTM成型过程中树脂/纤维界面性能,并对比分析了树脂对涂覆溶液定型剂前后的纤维浸润性能的影响。
5)  interface energy
界面能
1.
The model based on the interface energy can explain these two problems primitively in the dissolution of cementite.
建立了界面能模型以分析渗碳体溶解量的饱和现象及开始溶解门槛值问题,基于该模型可以初步解释渗碳体溶解过程中存在的这两个现象。
2.
And the solution of interface energy was obtained.
在Sine-Gorden势场下,导出相界面宽度,并求得相界面能量,得出其能量随着界面迁动速率增大而增大,从而表明了相变驱动力大的马氏体生长得快。
3.
As size of low dimensional materials decreases, which leads to the dramatic increase of surface/volume ratio, their properties are essentially controlled by related interface energetic terms, such as interface energy and interface stress.
随着低维材料尺寸的减小,表面体积比急剧增加,界面能和界面应力对材料性能的影响显著增加。
6)  interface performance
界面性能
1.
Taking SiCp/6066Al composite as an example,calculate and analyse influence of interface performance parameters(interface/matrix modulus ratio,interface Poisson ratio and interface volume fraction) and meso-structural parameters(particulate shape,arrangement pattern and dimensional variance mode) on elastic modulus of particulate reinforced aluminium matrix composite.
以SiCp/6066A l复合材料为例,计算和分析了界面性能参数(界面/基体模量比、界面泊松比和界面体积含量)及细观结构参数(颗粒形状、排列方式和尺寸变化方式)对颗粒增强铝基复合材料弹性模量的影响。
2.
The paper is on the basis of the researchful achievement in the world, the reinforced mechanism of woven-fiber-grid-reinforced concrete beams was studied in which elastic properties , flexural properties and interface performance.
本文在国内、外研究成果的基础上,从编织纤维格栅增强混凝土梁的弹性性能、抗弯性能及界面性能等方面具体研究了编织纤维格栅增强混凝土的增强机理。
3.
The influence rules of crack imperfections on interface performance are obtained.
对 CFS-GFS 混杂加固钢筋混凝土梁界面建立有限元分析模型,模型中考虑界面末端附近混凝土带裂缝工作,分别研究了模拟实际情况下不同尺寸、不同位置、不同数量的裂缝对加固界面性能的影响。
补充资料:界面能
分子式:
CAS号:

性质:又称总表面能或表面内能。是在恒温恒压条件下增加单位界(或表)面体系内能的增量。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条