1) nip angle
咬入角
1.
Based on rolling characters of longitudinal profiled(LP) plate,nip angle and biting condition are analyzed for LP plate rolling according to force condition.
基于纵向变截面轧制的特点,根据轧件受力分析了LP钢板轧制过程的咬入角和咬入条件。
2) nip angle
(压力加工)咬入角
3) bite angle
咬角
4) biting
[英]['baɪtɪŋ] [美]['baɪtɪŋ]
咬入
1.
Based on the analysis of the change in torque during plate rolling with respect to each pass reduction,it is known that the peak torque occurring in the biting phase of workpiece head is the key factor to restrain the pass reduction.
分析扭振在道次轧制中的变化特点,得知头部咬入阶段的峰值扭矩是制约道次压下量的关键因素。
5) angle of bite
咬角(轧辊)
6) biting condition
咬入条件
1.
Analysis of biting condition in radial-axial ring rolling;
环件径轴向轧制的咬入条件分析
补充资料：咬入角
咬入角
bitting angle
y00rUJIOO咬人角(bitting angle)轧制开始时轧件和轧棍最先接触的点与轧辊垂直中心线的构成的圆心角，一般以a表示(见图)。若设轧辊直径为D，轧件轧入前的厚度为H，轧出后的厚度为h，则咬入角a压下量从~H一h和轧辊直径D三者之间关系为从~D(1一eosa)。 妈 咬入角 (余望)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条