1) heat flux in the mold
结晶器热流
1.
According to operation practice,optimized process parameters were put forward to control the heat flux in the mold of thin slab caster.
针对影响薄板坯连铸结晶器热流的因素进行了分析,从生产实际出发,提出合理的工艺参数,优化工艺操作,以达到控制热流密度的目的。
2) heat transfer in mould
结晶器传热
1.
Serial Lecture of the Rudimentary Knowledge on the Transmission Phenomenon in Solidification Process of Continuous Cast Slab and Billet Lecture 16\ Principle of heat transfer in mould and its features of heat flow;
连铸坯凝固过程中传输现象基础知识系列讲座 第十六讲结晶器传热机制和热流特点
3) Hot-Top mould
热顶结晶器
5) circulation crystallizer
环流结晶器
6) thermal imaging figure of mould
结晶器热像图
1.
Based on experience of thin slab casting at Tangshan Steel,the application of thermal imaging figure of mould to predicting and controlling longitudinal crack of thin slab was analyzed.
结合唐钢薄板坯连铸的生产实践,分析了结晶器热像图在预测和控制薄板坯纵裂纹中的应用,同时阐述了影响薄板坯纵裂纹产生的其它因素,包括保护渣、拉速和过热度等,并提出了相应的控制措施,使唐钢薄板坯纵裂纹的发生率大幅度下降。
补充资料：二次再结晶(见再结晶晶粒长大)
二次再结晶(见再结晶晶粒长大)
secondary recrystallization
erCI 201」le」Ing二次再结晶(seeondary reerystallization) 见再结晶晶杠长大。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条