1) vertical borehole
立孔
1.
Aiming at complexly measuring gas pressure in vertical borehole in Wangfenggang Colliery,this paper puts forward a method of combined grouting with high pressure and sealing in groups.
针对望峰岗矿深井立孔测压复杂的客观实际,提出了高压复合注浆分组隔断封孔法。
2) edge oval pass
立椭孔型
1.
The new design method is applyed linear bottom of edge oval pass to institute the round arc one,which not only improved rolling stability but also enhanced the product quality and productivit
为解决圆钢轧制时圆弧槽底的立椭孔型稳定性差问题 ,将槽底圆弧段改为直线段。
3) caliber edging
孔型立轧
1.
In this paper, an analysis to caliber edging was carried out by full 3D rigid plastic FEM.
采用三维刚塑性有限元法对2S-Al板孔型立轧稳态过程进行了分析和比较,所得轧件断面形状、轧制力及轧制力矩与文献[1]的实验结果吻合很好,计算精度有所提高。
4) upright face
正立面孔
1.
In the present study,upright face,inverted face and nonface were used as cues in an orienting paradigm designed to elicit IOR.
研究了考察正立面孔、倒立面孔与非面孔线索对返回抑制的影响,发现在三种线索条件下均产生了返回抑制,而且返回抑制量没有差异。
5) inverted face
倒立面孔
1.
In the present study,upright face,inverted face and nonface were used as cues in an orienting paradigm designed to elicit IOR.
研究了考察正立面孔、倒立面孔与非面孔线索对返回抑制的影响,发现在三种线索条件下均产生了返回抑制,而且返回抑制量没有差异。
6) edging pass
立轧孔
1.
The piece can t be kept stable when it enter the edging pass from horizontal pass by traditional pass design method of K_3 to select the circular radium R.
按传统立轧K_3孔的设计方法选取椭圆半径R值,平孔轧件进入立轧孔时轧件不易保持稳定,通过分析和实践得出,椭圆半径R的取值范围应为:H_K/2>R>R_(min)。
补充资料：第二孔(继发孔)型缺损
第二孔(继发孔)型缺损
ostium secondary defect
是心房间隔在形成上发生障碍，一般缺损较大，多在卵圆孔附近称第二孔(继发孔)型缺损。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条