1) Ti-1Al-1Fe alloy
Ti-1Al-1Fe合金
2) Ti-5Mo-5V-5Al-1Cr-1Fe alloy
Ti-5Mo-5V-5Al-1Cr-1Fe合金
3) Mg-8Li-lAl
双相合金Mg-8Li-1Al
1.
The deformation modes during the process of equal channel angular pressing (ECAP) of Mg-8Li-lAl (mass fraction, %) alloy were discussed using the results of X-ray diffraction analyses.
以X射线衍射分析术为主要分析手段,探讨了双相合金Mg-8Li-1Al(质量分数, ％)在等通道转角挤压(ECAP)变形过程中的变形方式。
4) Ti Alloy
Ti合金
1.
Preparation and Research of Medical Ti Alloy Surface Biology Glass Coating;
医用Ti合金表面生物玻璃涂层的制备与研究
2.
Effect of collagen and heat treatment on the properties of HA coating on Ti alloy;
胶原和热处理对Ti合金表面HA涂层性能的影响
3.
Effect of rare earth element on microstructure and mechanical properties of powder metallurgy Ti alloy;
添加稀土元素对粉末冶金Ti合金显微组织和力学性能的影响
5) Ni-Ti alloy
Ni-Ti合金
1.
Study on the vacuum hot-pressed technology of Ni-Ti alloys based on Ni and Ti foils;
基于箔带材Ni-Ti合金的真空热压工艺研究
2.
Preparation of Ni-Ti alloy by direct electrochemical deoxidation in low temperature molten salt
低温熔盐电解制备Ni-Ti合金
3.
The results show that Ti(C,N)-based cermets without Ni-Ti alloy present typical core-rim microstructure and nearly spherical shape of hard phase; the microstructure of cermets gets finer,and the shape of hard phase becomes multiangular with the increasing of Ni-Ti alloy,the interface between hard phase.
采用粉末冶金方法真空烧结制备了添加Ni-Ti形状记忆合金的Ti(C,N)-Co系金属陶瓷,研究了Ni-Ti合金对Ti(C,N)基金属陶瓷显微组织和力学性能的影响。
6) Ti-Ni alloy
Ti-Ni合金
1.
Preparation of diamond-like carbon films on Ti-Ni alloy by pulsed vacuum arc technique;
Ti-Ni合金上镀制类金刚石薄膜研究
2.
At the same time, the DSC curve gives the Ti-Ni alloy’s martensitic start temperature (Ms) and end temperature (Mf), the austenitic start temperature (As) and end temperatur.
同时,给出了Ti-Ni合金的马氏体起始温度Ms,马氏体结束温度Mf,奥氏体起始温As和奥氏体结束温度Af,并对其相变过程进行了判断。
3.
DSC curves in Ti-Ni alloys can be classified into 6 kinds.
结果表明,Ti-Ni合金的DSC曲线分6种类型。
补充资料：Ti_(3)Al基合金(金属间化合物)涡轮导风板
Ti_(3)Al基合金(金属间化合物)涡轮导风板
TiaA，基合金(金属间化合物)涡、、风*。利;:，
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条