1) combination of labor
合工
1.
With the rise of theory on Business Process Reengineering and Project Management, the theory of "division of labor" is claimed to be outdated and that it should be substituted by the theory of "combination of labor".
随着BPR和项目管理在企业管理中的兴起 ,出现了用“合工”思想替代“分工”理论的说法 ,并称“分工”理论过时了。
2) coupling process
耦合工艺
1.
Study on catalytic distillation coupling process of isobutene oligomerization;
异丁烯齐聚反应精馏的耦合工艺研究
2.
Research on coupling process of short-cut nitrification and simultaneous nitrification and denitrification
短程硝化与同时硝化反硝化耦合工艺的研究
3) synthetic process
合成工艺
1.
Studies on Synthetic Process of Isocyanate Resins for Particleboard;
刨花板用异氰酸酯胶粘剂合成工艺的研究
2.
Study on synthetic process of low toxic urea-formaldehyde resin for bamboo particleboard
竹碎料板用低毒脲醛树脂的合成工艺研究
3.
In this paper,based on the brief review of the development of waterborne polyurethanes,the synthetic processes of anionic,cationic,zwitteri- onic and nonionic waterborne polyurethanes are introduced in detail,and the advantages and disadvantages of their preparation methods are discussed.
在概述水性聚氨酯发展历程的基础上,详细阐述了阴离子型、阳离子型、两性离子型、非离子型水性聚氨酯的合成工艺路线、制备方法的优缺点,以及水性聚氨酯的主要应用领域,并指出水性聚氨酯的发展方向。
4) composite process
组合工艺
1.
The printing and dyeing wastewater was treated by a pulse cyclic fluidized bed(CFB) composite process with engineering scale of 5000m3/d.
采用脉冲循环流化床与物化沉淀池的组合工艺对某公司的印染废水进行了处理。
2.
Composite process composed of inorganic macromolecule flocculent polymeric ferric sul-fate (PFS) with leading effective microorganism (EM) was used for algae control of raw water from eutrophic water body.
结果表明:组合工艺在最佳工作条件下,即PFS为30 mg/L,VEM/V污水为5/10 000,曝气时间为HRT/2(HRT=5 d),水温为25℃,pH为中性时,原水中叶绿素a,TP,COD,TN的去除率分别可达93%,89%,85%,60%。
3.
The experimental method of aeration biological filter-chemical precipitation-sand filter composite process and water quality situations in experiment are introduced.
介绍了曝气生物滤池—混凝澄清—砂滤组合工艺的试验方法及其试验用水水质情况,并分析了该工艺对CODCr,NH3-N,总硬度,总磷的去除效果,得出了一些有意义的试验结论,为中水回用工程设计提供了可靠的参数。
5) synthetic technology
合成工艺
1.
Study on synthetic technology and property of phenol modified urea-formaldehyde resins;
苯酚改性脲醛树脂合成工艺及性能的研究
2.
Study on synthetic technology of environment-protecting typeurea-formaldehyde resin;
环保型脲醛树脂胶合成工艺的探讨
3.
Study on synthetic technology of aliphatic hydroxy sulphonate condensate superplasticizer;
脂肪族高效减水剂合成工艺研究
6) technological combination
工艺组合
1.
The paper introduces the different process combination and looks for the rational technological combination by comparative analysis on the basis of analyzing effects of tea factors on the quality of Meijiangcuipian tea according to the principle of tea process.
详细介绍了湄江翠片茶各种工艺组合,并根据制茶原理,分析了制茶因子对湄江翠片的品质影响,通过分析对比,找出了湄江翠片比较合理的工艺组合。
补充资料:非合金工具钢
non-alloytoolsteel:含碳很高(0.7~1.35)、实际上不含合金元素的钢(钢种)。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条