2) trigger points
触发点
1.
Objective: To study the characteristics of myofacial trigger point pain in lumbar and breech region with theirs referred buttock and leg pains, and to investigate the effects of repeated punctures into trigger points at involved muscles associated a stretch therapy to these muscles.
目的:探讨腰臀肌触发点疼痛和其腿部牵涉痛的特征,观察以反复针刺为主,受累腰臀肌牵张为辅的治疗效果。
2.
The different trigger points of LDMOS’s intrinsic npn transistor by isothermal and non-isothermal methods are compared and analyzed.
提出并证明了等温分析和电热分析分别得到的LDMOS的触发点是不同的;分析了局部晶格温度在空间上的分布特点;并提出晶格温度弛豫时间会影响漏极电压弛豫时间。
3.
Objective: To observe and analyze the effects of treatments and characteristics of referred pains around knee induced by myofacial trigger point pains in some muscles of lower extremities and investigate the effects of repeated punctures into these trigger points at involved muscles associated a stretching therapy to these muscles.
目的:观察引起膝关节周围疼痛的下肢肌筋膜触发点特征和以反复针刺为主,受累下肢肌牵张为辅的治疗效果。
3) trigger point
触发点
1.
Object: To observe and study periarthritis of shoulder treated with myofascial trigger points around shoulder muscles and clinical effects.
目的:肩周肌筋膜炎的触发点治疗效果的临床观察。
4) Service Switching Point(SSP)
触发点TDP
5) heating of contact
触点发热
6) ignition
[英][ɪɡ'nɪʃn] [美][ɪg'nɪʃən]
点燃，触发
补充资料：闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
（一）加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度（mm） | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
（二）结构性能 | |||||||
1、离合器、制动器接通率，当滑块行程次数≤16次/分时为70%，≤25次/分时为60%，≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
（三）噪声dB（A） | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | ＞88 | |||
2、公称力＞400kN | ≤87 | ≤88 | ≤90 | ＞90 | |||
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条