说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 桩身上浮
1)  pile shaft floating up
桩身上浮
2)  upfloat
桩体上浮
1.
Based upon the results obtained from geological inspection, design, monitoring and construction, the upfloat of prestressed pipe pile is analysed.
针对预应力管桩桩体上浮问题从地质条件、设计、检测及施工等方面进行了分析,进而提出预应力管桩施工中需要注意的几个问题,供同行参考。
3)  risen pile
上浮桩
1.
The risen pile cause of some immersed pipes are analyzed in this paper through an engineeringexample.
同时,提出了应用静压法处理上浮桩的思路。
4)  pile body
桩身
1.
It analyzes the reinforcement mechanics of lime pile in the building from three aspects of earth among pile,pile body,compound foundation,and introduces the lime pile design method and project test method,which shows the lime pile used is suited to reinforce the foundation treatment in the existing buildings.
从桩间土、桩身、复合地基三方面分析了石灰桩在建筑物中的加固机理,结合工程实例,介绍了石灰桩的设计方法及工程质量检验方法,证明了采用石灰桩进行既有建筑地基加固处理是可行的。
2.
Normally,the ram-compaction pile body is bored concrete pile,whose quality can\'t be guaranteed in deep and thick soft ground.
复合载体桩桩身常用混凝土灌注桩,在深厚软土地区其桩身质量不易保证;采用PHC预应力管桩作复合载体桩桩身,既可提高其桩身承载力,又易于保证桩身质量。
5)  floating pile
浮桩
1.
Based on the contrast of grouting and re-beating of floating piles,the latter should be adopted in soft soil foundation.
针对某广场在高强预应力管桩施工中出现大量浮桩的现象,研究了软土地基中管桩浮桩对桩侧阻、端阻和承载力的影响。
2.
Aimed at the phenomena of floating pile in construction of 100000 m2 high building with prestressed concrete pipe piles,the influence of floating on shaft resistance,toe resistance and bearing capacity of pile were studied through the analysis of static load tests of engineering piles.
针对某广场10万m2高层建筑在预应力管桩施工中出现大量浮桩的现象,通过对试打桩、工程桩的静载荷试验结果进行对比分析,研究了软土地基中管桩挤土上浮对桩侧阻、端阻和承载力的影响。
3.
For possible floating piles in strengthening weak foundation of highway with cement mixing piles, the relationship be-tween total settlement of the foundation and thickness of underlying un-strengthened soil layer is derived on the basis of two models.
在两个模型的基础上 ,对水泥搅拌桩加固高速公路可能出现的浮桩情况 ,研究了地基总沉降和未打穿土层厚度的关系 ;对可能出现的薄硬夹层情况 ,探讨了地基总沉降和中间薄硬夹层厚度的关系。
6)  round the bitt
上桩
补充资料:桩身质量检验
      桩作为地下承重构件,除依赖地基土所具有的足够承载力外,桩身还必须具有符合设计要求的截面尺寸、长度、强度及整体致密性,合称结构完整性。随着大直径钻孔灌注混凝土桩在结构物中的大量应用,对桩的质量要求愈益严格。但在工程中灌注桩会因工艺不良而造成桩身混凝土离析、缩颈、夹泥、形成空洞或断裂等从地面不易察觉的隐患,预制桩桩身亦可能由于锤击应力过大或混凝土强度不足而断裂或破碎,影响安全、耐久及地基承载力的发挥,因此,需要在施工中或竣工后进行桩身质量检验。
  
  当地下水位较低,桩身缺陷位置不深,并已探明时,可采用开挖法进一步查核并确定补救措施。也可用钻取混凝土芯的方法,并根据其钻孔渗水、芯样强度、破碎程度、钻进速率和钻进耗能的变化或配合钻孔电视或孔径测量等进行检验。但这仅反映钻孔所经过的小范围内桩身的质量情况。采用时须注意钻具的挺直度及钻孔的垂直。整体加压法是在桩身中预埋构件自行锚定,再以千斤顶加压检验整体桩身强度。此外,近年已开始研究射线散射、声测、激振等无损检验技术。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条