1) pre-stowage
预配
1.
Optimum model and algorithm of containership′s pre-stowage planning in full routes;
集装箱船全航线预配优化模型与算法研究
2) shrink-fitting
预紧装配
3) prebatching
预配料
1.
Practice on prebatching with wet fly-ash and bauxite;
通过调研和摸索,采用湿排粉煤灰和铝矾土,按1∶2预配料,控制预配料的水分在10%左右进行生产,并进行了加大下料溜子角度(至75°),在易堵部位加装高分子量聚乙烯板材等配套工艺改进,获得了较好的效果,原料磨的产量由180t/h提高到200t/h,熟料产量稳定在2750t/d以上,熟料强度62MPa。
5) preassembly
[pri:ə'sembli]
预装配
1.
Primary technologies for collaborative preassembly;
协同预装配若干技术研究
2.
Based on requirement analysis of the preassembly, assembly sequence, and assembly route of cooperative product assembly activity, an information model including part information, assembly information and decision-making information in an assembly design was presented to satisfy all information requirements of the cooperative assembly design.
为满足协同装配设计所需的信息,分析了协同装配中预装配、装配顺序规划和装配路径规划等活动对装配信息模型的需求,给出了协同装配模型的信息构成,包括零件信息、装配信息和设计决策信息3部分。
6) Pre-assembly
预装配
1.
Automobile wire-harness pre-assembly is the process to extract independent sub-wire-harnesses from the entire wire-harness.
汽车线束预装配是在整车线束中提取多个子线束的过程。
补充资料：设备安装前的准备工作——设备的预装配与预调整
设备安装前的准备工作——设备的预装配与预调整 | ||
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条