说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 回辉
1)  Huihui
回辉
1.
Huihui: a Self-Formulation of Hui Muslim;
回辉:回族穆斯林的另一种自我表述
2)  TBSS
辉斑回波
1.
The results indicate that in the hail event there existed inflow gap and three-body scatter spike(TBSS) on the PPI,strong echo pendency and limitary weak echo region(WER) on the ver.
雷达回波分析表明,这次冰雹云在平面位置显示(PPI)上具有入流缺口和辉斑回波(TBSS),在垂直剖面上具有强大的回波悬垂和有界弱回波区的回波墙等特征。
3)  brightness [英]['braitnis]  [美]['braɪtnɪs]
辉度
1.
The influencing factors of the brightness of luminescent switch were studied.
研究了影响夜光开关辉度的因素。
2.
The brightness,afterglow time and stability against light were measured.
分别将ZnS类发光颜料及碱土铝酸盐类发光颜料加入到聚丙烯中,制成ZnS发光塑料和碱土铝酸盐发光塑料,测定其辉度、余辉时间及光稳定性。
3.
Improving the CCFL light efficiency is the one of the most efficient way to increase the surface brightness of BLU.
提高背光模组灯管光线的利用率是增加背光模组表面辉度的有效方法之一。
4)  recalescence [英][,rikə'lesns]  [美][,rikə'lɛsəns]
再辉
1.
Analysis on recalescence and nucleation of undercooled Cu-20%Pb hypomonotectic alloy;
深过冷Cu-20%Pb亚偏晶合金的再辉与形核分析
2.
During solidification it was found that only once recalescence occurred for those melts with low undercoolings (<147K), and twice recalesences were observed for those melts with high undercoolings (≥147K).
研究了CuPb偏晶合金凝固组织随过冷度的演化规律,探讨了深过冷下合金的凝固机制,发现合金在小过冷度(<147K)情况下只有一次再辉,而在大过冷度下(≥147K)有两次再辉现象。
3.
The research result shows that: The character of nucleation is obvious relatively along the cooling graph of the negative temperature gradient melt solidification; The character of "second recalescence" appears ob.
研究了63~292K热力学过冷度范围内,Cu-Ni单相合金的凝固组织演化规律,分析了负温度梯度熔体凝固过程中的形核与再辉行为。
5)  afterglow [英]['ɑ:ftəɡləʊ]  [美]['æftɚ'glo]
余辉
1.
Development on the blue-green long afterglow phosphor doped RE;
稀土蓝绿色长余辉发光粉的研制
2.
The Characteristics of the Prompt Gamma-rays and Early X-ray Afterglows of Gamma-ray Bursts;
伽玛暴及其早期X射线余辉的观测特征
3.
Unusual Afterglow Properties of Tm3+ Doped Yttrium Oxysulfide;
掺铥硫氧化钇的特殊余辉性质
6)  Double glow
双辉
1.
In this paper,six processes about multi-element alloying sequence had been designed to alloying with N,C and Ti on the surface of 20 carbon steel by double glow plasma surface alloying(DGPSA).
本文利用双辉技术在20钢表面设计了六种不同顺序C、N、Ti三元共渗的工艺方案,以研究合金元素渗入顺序对渗层的影响。
2.
The Double glow plasma surface alloying has a complex process and a lot of technological parameters.
双辉等离子表面冶金工艺流程复杂、参数众多,且各影响因素与渗金属效果之间是非线性的关系,难以建立反映工艺内在规律的数学模型,给双辉等离子表面冶金技术的研究带来不便。
补充资料:辉辉
1.明亮貌。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条