说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 光失电压
1)  photogenerated voltage
光失电压
2)  voltage instability
电压失稳
1.
Analysis of the probability of voltage instability based on Thevenin equivalent parameters;
基于戴维南等值参数的电压失稳概率解析
2.
Mid and longer-term voltage instability are usually caused by the continuing increase of the load, and is characterized by a period when the voltage drop down quite slowly.
为理解中长期电压失稳现象的本质,采用小扰动分析法在系统特性曲线上展示静态特性不同的具体负荷的静态电压稳定域的确定过程,解释了失稳过程中系统电压稳定于低水平的现象,指出不同负荷在系统特性曲线下半支的稳定情况由负荷的静态特性所决定;在此基础上还讨论了目前两类截然不同的中长期电压失稳现象的机理解释,即无功功率和有功功率不平衡解释,指出这两种机理之间存在着紧密的联系和统一之处。
3.
In order to make up the deficiency of traditional analytical method used in the research of voltage stability problem, we need to know the probability information concerned with voltage instability.
为了克服传统分析方法在电压稳定问题研究中存在的不足,需要掌握与电压失稳现象相关的一些概率信息。
3)  offset voltage
失调电压
1.
Ignoring input bias current and input noise voltage of op amp in four linearity circuits,the output expressions for affect of offset voltage on measuring system were given.
在忽略放大器输入偏置电流和输入噪声电压的情况下,给出了四种校正电路中放大器失调电压对测量系统影响的输出表达式,并分析比较了每一种校正方法的特点,得到最佳的测量线路,使失调电压及其漂移的影响减小了5倍。
2.
The highlight of the design is that the input offset voltage of the comparator is used as its switching point voltage.
针对CMOS集成电路中高精度低跳变电压点电压比较器设计的难点,设计了一种具有超低跳变电压点的新型电压比较器,其特点是利用输入失调电压来设置比较器的跳变点电压值,满足了许多需要用到此类比较器而用传统方法无法满足要求的场合,电路在1。
3.
To consider the propagation delay,offset voltage and other factors,the structure of the preamplifier and compare-latch circuit is analyzed and a high-speed voltage comparator is designed.
本文综合考虑了比较器的传输延时、失调电压等因素,分析了前置放大器和比较锁存电路的结构,在此基础上设计了一个基于CSMC0。
4)  loss of voltage
电压消失
5)  Voltage loss
电压损失
1.
Simplified calculation of voltage loss of road lamp;
路灯电压损失的简化计算
2.
Relation between line loss rate and voltage loss of power lines
线路的线损率与工程设计中电压损失的关系
3.
Based on a typical example of power network in a coal mining area, the methods of cable selection of main line and branch line, which can meet the voltage loss both on the conditions of normal equipment start and largest and farthest equipment start for ensuring system safety and stable operation were introduced.
本文通过煤矿某采区供电系统的典型示例,介绍在正常和最大最远设备启动时,满足电压损失条件下如何选择干线、支线电缆,以确保系统安全、稳定的运行。
6)  residual voltage
失电残压
1.
The research of the residual voltage of induction motor after dumping and its influence during restoration
感应电动机失电残压的研究及其对重合过程的影响
2.
The changing rule of the residual voltage was analyzed systematically by the space-vector based model of induction motors, and the analytic formula of the residual voltage was deduced, and then, its correctness was verified by numerical simulation.
文章采用空间向量表示的感应电机数学模型,对电机失电残压的变化规律进行了系统分析,推导出失电残压解析式,并利用状态方程数值仿真方法进行了验证。
补充资料:标准操作冲击电压波形(见冲击电压发生器)


标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform

  b .oozhun CooZuo ChongJld,onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条