1) titling optical axis
倾斜光轴
1.
In this peper the defects of conventionalwave plate is analyzed,and the design consideration of a wave plate with titling optical axisare mainly discussed.
本文分析了常规波片的缺点,重点讨论了倾斜光轴波片的设计方法。
2) inclination of optical axis
光轴倾斜度
1.
Taking the JJY model spectrometer as an example,the focusing and inclination of optical axis are discussed in this paper.
本文以JJY型分光计为例,对分光计的聚焦与光轴倾斜度这两方面的调节做了系统论述。
3) tilting axis
倾斜轴
4) misalignment
['misəlainmənt]
轴倾斜
1.
Couple Research on Dynamics and Tribology of Crankshaft-bearing System Considering Misalignment Caused by Elastic Deflection;
计入轴倾斜的曲轴-轴承系统动力学摩擦学耦合分析
2.
Multidisciplinary coupling analysis on dynamics,tribology, strength and stiffness for a shaft-bearing system was studied herein,considering misalignment caused by shaft deformation on variable load.
轴倾斜使得轴-轴承系统的动力学响应、润滑性能以及轴颈表面动应力发生改变。
3.
Multidisciplinary coupling among dynamics,tribology and elastic mechanics(strength and stiffness of crankshaft) of the crankshaft-bearing system of a four cylinder diesel engine was studied by considering the misalignment caused by the elastic deflection of the crankshaft,ADAMS and ANSYS special software were used to solve the coupling problem.
采用动力学仿真软件ADAMS和有限元分析软件ANSYS,辅以手工编程相结合的方法,研究了计入曲轴倾斜时某4缸柴油机曲轴-轴承系统动力学、摩擦学和弹性力学(曲轴的刚度和强度)耦合分析问题。
5) journal misalignment
轴颈倾斜
1.
The governing equation of hydrodynamic pressure for rough surfaces under steady-state conditions,given by Patir and Cheng,was utilized to analyze the hydrodynamic lubrication characteristics when considered journal misalignment,viscosity-pressure relationship of lubricating oil,roughness of bearing surfaces.
结果表明,在分析倾斜轴颈轴承的润滑性能时,必须考虑轴承表面变形;在偏心率和轴颈倾斜角较大时,计及轴承表面变形以后,考虑轴承表面形貌参数对轴承润滑性能分析结果的影响不明显。
2.
The surface roughness affects lubrication characteristics of misaligned bearing when eccentricity ratio and angle of journal misalignment are all large and not considering surf.
不考虑轴承表面变形情况下,当偏心率较大且轴颈倾斜角也较大时,表面粗糙度对倾斜轴颈轴承润滑性能产生影响;表面形貌方向参数在最小油膜厚度与表面综合粗糙度的比值较小时对倾斜轴颈轴承润滑性能产生显著影响。
6) Shaft misalignment
轴倾斜
1.
Coupling analysis between dynamics and tribology for a flexible shaft bearing system is discussed in this paper, considering shaft misalignment by a variety of working condition such as shaft deformation, error of manufacture and setting.
探讨了变载荷作用下计入轴倾斜时轴-轴承系统动力摩擦学耦合问题。
补充资料:光轴
见晶体光学。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条