1) howking temperature
Howking温度
2) Hawking Unruh thermal spectrum
HowkingUnruh热谱
3) Holding Temperature
保温温度
1.
Microstructure Evolution of Hypereutectic Al-Si Alloy Semi-slurry in Holding Temperature;
研究了保温时间和保温温度对电磁搅拌ZL117合金半固态浆料稳定性的影响。
4) isothermal temperature
等温温度
1.
Effect of isothermal temperature on microstructure of semi-solid 2024 alloy during partial remelting;
等温温度对半固态2024合金部分重熔组织的影响
2.
Based on this principle,we have analized the isothermal temperature range in which thecracks are apt to arise.
ZGMn13钢水韧处理加热过程中不同等温温度将产生不同的显微组织，根据这个原理，分析了容易产生裂纹的等温温区，并推荐了最佳等温温度。
3.
The results compared with those obtained by conventional quenching and tem-pering,show that 300M steel transformed with isothermal temperature below Ms has a mix structure ofmartenite,lower bainite and retained astenite.
研究了四种含碳量、三种等温温度与力学行为的关系，并与淬火回火３００Ｍ钢进行比较得出，３００Ｍ钢在Ｍｓ点以下温度等温获得Ｍ＋Ｂ＿下＋Ａ＿Ｒ混合组织、超高强度和优良的韧性。
6) constant temperature
恒温温度
1.
On the basis of experiments and analysing the effects of the constant temperature and curing time on the strength of fly-ash, the best curing temperature and time are obtained.
在实验的基础上通过对恒温温度及养护时间对粉煤灰强度影响的分析,得出粉煤灰制品的最佳养护温度和时间。
2.
Based on analyzing the obtained data,the influences of selecting constant temperature (℃)and acting time(hour)on the research results,are discussed.
在分析试验数据的基础上,探讨了试验中对恒温温度(℃)和恒温时间(小时)的选择对研究结果的影响。
3.
The behavior of circular stub columns of concretefilled steel tubes with circular sections after high constant temperature subjected to axial load was investigated experimentally and the relation of the loadstrainh was mainly researched into.
重点研究了载荷 应变的变化规律,在分析试验数据的基础上,探讨了试验中恒温温度t和恒温时间h的选择对试验结果的影响。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条