CO2激光热固定,thermal fixing by CO 2 laser,音标,读音,翻译,英文例句,英语词典

您的位置：首页 -> 词典 -> CO2激光热固定

1) thermal fixing by CO 2 laser 点击朗读

CO2激光热固定

2) CO 2 fixation 点击朗读

CO2固定

例句>>

3) CO2 fixation 点击朗读

固定CO2

The effects of CO2 donor,CO2 flow rate,agitation rate,culture temperature and pH value on CO2 fixation rate and succinic acid productivity were investigated.

在富含CO2的厌氧环境下,产琥珀酸放线杆菌NJ113固定CO2合成丁二酸作为主要代谢终产物。

4) CO2 laser 点击朗读

CO2激光器

A high frequency modulated high power CO2 laser is used as the excitation source to heat up the sensor under test.

用对CO2激光器输出10。

The analysis results show that the rectangular waveguide CO2 laser can manifest a far field intensity distribution of coherent spatial suppressed single peak,which is similar to that from a phase coupled waveguide array laser, and its far field intensity distribution changes periodically with the increase of the resonator length.

分析表明,矩形波导CO2激光器在一定条件下可以获得类似阵列波导的远场同相相干压窄单峰输出,输出远场相干强度分布随腔长变化呈现周期性地交替变化等特征。

In order to get the high output power,a RF excited diffusively cooled all-metal slab waveguide CO2 laser was reported,in which gas discharge region was constructed by two aluminum side walls and aluminum electrodes.

为了获得较高的激光输出功率,介绍了射频激励扩散冷却全金属板条波导CO2激光器,放电区域由左右两个铝合金壁和上下两个铝合金电极构成,放电区域高2 mm,宽20 mm,长386 mm,工作气体混合比CO2:N2:He:Xe=1:1:3:0。

5) CO_2 laser 点击朗读

CO2激光

The amorphous Fe_(78)Si_9B_(13) alloy was partially crystallized when it was irradiated by CO_2 laser beam with 20mm spot diameter for 20 sec at 250W and 300W as the laser power.

在CO2激光散光斑直径20mm的情况下,分别选择在不同功率静置的条件下辐照Fe78Si9B13非晶带实现部分晶化·用穆斯堡尔谱、X射线衍射和扫描电镜对原始非晶样品(Fe78Si9B13)和晶化后样品的微观结构进行了分析·结果表明:在CO2激光散光斑直径一定的条件下(20mm),分别选择激光功率250W和300W辐照非晶Fe78Si9B13样品20s,非晶样品可以实现约6%和9%的晶化·激光辐照非晶Fe78Si9B13合金的晶化相为αFe(Si),样品发生了织构现象,晶粒沿(200)面大量析出·激光晶化相产生在非晶带表面晶化层中·在其他条件一定的情况下,样品的晶化量随着激光功率的增加而增加

5B_9 amorphous ribbon samples were exposed to CO_2 laser irradiation with various powers (150 W,200 W,250 W,300 W) and the same scanning speed (20 mm/s) in order to produce nanocrystalline phase on the surface of amorphous Fe_ 73.

在相同激光扫描速度(20mm/s)和不同激光功率(150W,200W,250W,300W)工艺条件下,利用CO2激光对铁磁Fe73。

The physical and chemical processes about CO_2 laser-induced deposition of metal Ag from aqueous solution were studied.

利用低功率CO2激光,从水性溶液中诱导沉积金属Ag,存在物理化学过程。

更多例句>>

6) CO 2 laser 点击朗读

CO2激光器

补充资料：poly(bisphenol a-co-4-nitrophthalic anhy-dride-co

CAS：61128-46-9
分子式：(C31H20O8·C6H8N2)x
中文名称：5,5'-[(1-甲基亚乙基)双(4,1-亚苯氧基)]双-1,3-异苯并呋喃二酮与1,3-亚苯二胺的聚合物

英文名称：1,3-Isobenzofurandione, 5,5'-[(1-methylethylidene)bis(4,1-phenyleneoxy)]bis-, polymer with 1,3-benzenediamine

3-isobenzofurandione, 5,5'-[(1-methylethylidene)bis(4,1-phenyleneoxy)]bis- polymer with 1,3-benzenediamine

poly(bisphenol a-co-4-nitrophthalic anhy-dride-co

1,3-Isobenzofurandione,5,5'-[(1-methylethylidene)bis(4,1-phenyleneoxy)]bis-,polymer with 1,3-benzenediamine

说明：补充资料仅用于学习参考，请勿用于其它任何用途。

参考词条

脉冲CO2激光 CO2激光焊接 CO2激光打孔

CO2激光焊 CO2、YAG激光植被固定CO2 CO2固定反应

说明：双击或选中下面任意单词，将显示该词的音标、读音、翻译等；选中中文或多个词，将显示翻译。
	您的位置：首页 -> 词典 -> CO2激光热固定 1) thermal fixing by CO 2 laser CO2激光热固定 2) CO 2 fixation CO2固定例句>> 3) CO2 fixation 固定CO2 1. The effects of CO2 donor,CO2 flow rate,agitation rate,culture temperature and pH value on CO2 fixation rate and succinic acid productivity were investigated. 在富含CO2的厌氧环境下,产琥珀酸放线杆菌NJ113固定CO2合成丁二酸作为主要代谢终产物。 4) CO2 laser CO2激光器 1. A high frequency modulated high power CO2 laser is used as the excitation source to heat up the sensor under test. 用对CO2激光器输出10。 2. The analysis results show that the rectangular waveguide CO2 laser can manifest a far field intensity distribution of coherent spatial suppressed single peak,which is similar to that from a phase coupled waveguide array laser, and its far field intensity distribution changes periodically with the increase of the resonator length. 分析表明,矩形波导CO2激光器在一定条件下可以获得类似阵列波导的远场同相相干压窄单峰输出,输出远场相干强度分布随腔长变化呈现周期性地交替变化等特征。 3. In order to get the high output power,a RF excited diffusively cooled all-metal slab waveguide CO2 laser was reported,in which gas discharge region was constructed by two aluminum side walls and aluminum electrodes. 为了获得较高的激光输出功率,介绍了射频激励扩散冷却全金属板条波导CO2激光器,放电区域由左右两个铝合金壁和上下两个铝合金电极构成,放电区域高2 mm,宽20 mm,长386 mm,工作气体混合比CO2:N2:He:Xe=1:1:3:0。 5) CO_2 laser CO2激光 1. The amorphous Fe_(78)Si_9B_(13) alloy was partially crystallized when it was irradiated by CO_2 laser beam with 20mm spot diameter for 20 sec at 250W and 300W as the laser power. 在CO2激光散光斑直径20mm的情况下,分别选择在不同功率静置的条件下辐照Fe78Si9B13非晶带实现部分晶化·用穆斯堡尔谱、X射线衍射和扫描电镜对原始非晶样品(Fe78Si9B13)和晶化后样品的微观结构进行了分析·结果表明:在CO2激光散光斑直径一定的条件下(20mm),分别选择激光功率250W和300W辐照非晶Fe78Si9B13样品20s,非晶样品可以实现约6%和9%的晶化·激光辐照非晶Fe78Si9B13合金的晶化相为αFe(Si),样品发生了织构现象,晶粒沿(200)面大量析出·激光晶化相产生在非晶带表面晶化层中·在其他条件一定的情况下,样品的晶化量随着激光功率的增加而增加 2. 5B_9 amorphous ribbon samples were exposed to CO_2 laser irradiation with various powers (150 W,200 W,250 W,300 W) and the same scanning speed (20 mm/s) in order to produce nanocrystalline phase on the surface of amorphous Fe_ 73. 在相同激光扫描速度(20mm/s)和不同激光功率(150W,200W,250W,300W)工艺条件下,利用CO2激光对铁磁Fe73。 3. The physical and chemical processes about CO_2 laser-induced deposition of metal Ag from aqueous solution were studied. 利用低功率CO2激光,从水性溶液中诱导沉积金属Ag,存在物理化学过程。更多例句>> 6) CO 2 laser CO2激光器补充资料：poly(bisphenol a-co-4-nitrophthalic anhy-dride-co CAS：61128-46-9 分子式：(C31H20O8·C6H8N2)x 中文名称：5,5'-[(1-甲基亚乙基)双(4,1-亚苯氧基)]双-1,3-异苯并呋喃二酮与1,3-亚苯二胺的聚合物英文名称：1,3-Isobenzofurandione, 5,5'-[(1-methylethylidene)bis(4,1-phenyleneoxy)]bis-, polymer with 1,3-benzenediamine 3-isobenzofurandione, 5,5'-[(1-methylethylidene)bis(4,1-phenyleneoxy)]bis- polymer with 1,3-benzenediamine poly(bisphenol a-co-4-nitrophthalic anhy-dride-co 1,3-Isobenzofurandione,5,5'-[(1-methylethylidene)bis(4,1-phenyleneoxy)]bis-,polymer with 1,3-benzenediamine 说明：补充资料仅用于学习参考，请勿用于其它任何用途。参考词条脉冲CO2激光 CO2激光焊接 CO2激光打孔

©2011 dictall.com