说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 静电场强度
1)  strength of electrostatic field
静电场强度
1.
By make use of the general formula of anisotropic electrostatic potential,the authors give a general formula of the strength of electrostatic field in linear anisotropic medium and the Gauss theorem;and solve the electrostatic field of the distribution of several kinds of electric charges in the above medium.
利用各向异性静电势的普遍公式,给出在线性各向异性介质中的静电场强度的普遍公式和高斯定理,可求出在上述介质中若干种电荷分布的静电场,充实各向异性静电场的一个基本内容。
2)  ectrostatic field strength
静电场强度;静电场强度
3)  electric stress
电场强度,电应力,静电强度
4)  electric field strength
电场强度
1.
The influence to ADSS cable of electric field strength;
电场强度对ADSS光缆的影响
2.
Calculation for maximum electric field strength within cover contact;
触头盒内最大电场强度的计算
3.
When the electric field strength was changed from 100 V/cm to 375 V/cm,the mobility was varied as a complex function of fragment size and electric field.
改变电场强度100~375V/cm,得到的迁移率曲线与电场强度和DNA片段长度成复杂的函数关系,已有的经典理论模型:Ogston模型、Reptation无拉伸模型和Reptation拉伸模型都不能正确地描述实验观察到的迁移率随电场强度和DNA片段长度的变化情况。
5)  Electric-field intensity
电场强度
1.
The electric-field intensity inside and outside of the spherical cavity in polarized homogeneous dielectric are recalculated by use of Laplace equation, and the conclusion are different from those in some textbooks.
运用拉普拉斯方程对均匀极化电介质被挖出一个球形空腔的内、外电场强度进行了新的运算,得到了与一些教材不同的结论。
2.
By using the theory of complex variable function and conformal transformation, the cross-section of two parallel columns are converted into the cross-section of two parallel plates, and the capacity, electric potential and electric-field intensity of the two parallel columns per unit length are calculated.
运用复变函数、保角变换等理论,把横截面为两平行圆柱变换成横截面为两平行板,计算出两平行圆柱单位长度的电容、电势和电场强度。
3.
Electric-field intensity acting on dielectric and the operation temperature of dielectric are the main factors stressing on the power capac itors.
影响电力电容器的使用寿命的主要因素即作用在介质上的电场强度和介质的运行温度。
6)  Electric field intensity
电场强度
1.
The distribution diagrams of electric potential and electric field intensity in dot-charge system based on MATLAB;
基于MATLAB构建点电荷系的电势与电场强度分布图
2.
Calculation of electric field intensity of high voltage direct current transmission lines;
高压直流输电线路电场强度计算方法
3.
Series solution of electric field intensity on perpendicul araxis of elliptic charged ring;
椭圆形带电环垂直轴上的电场强度级数解
补充资料:火炸药静电火花感度
分子式:
CAS号:

性质:在静电放电作用下,火炸药发生燃烧或爆炸的难易程度。一是指火炸药是否容易产生静电和静电量,二是指火炸药对静电放电火花是否敏感。一般用100%不爆炸所能承受的最大静电火花能量,50%爆炸所需静电火花能量或100%爆炸所需最小静电火花能量表示。测定结果与试验装置、环境条件(温度、湿度)和药剂的物理化学状态(纯度、粒度及粒度分布、结晶形状、制备方法等)均有关。测定仪器有多种,其原理多系使炸药试样在一定装药条件下,承受尖端放电的电火花作用,观察试样是否易被引爆。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条