1) Stress accumulating speed
地震应力积累速率
2) moment accumulation rate
地震距积累率
3) strain-accumulating rate
应变积累速率
1.
According to the deficiency of the strain accumulating and releasing curves and the previous models, the strain-accumulating rate of the strain accumulating and releasing model has been deduced based on the G-R relation and the empirical formula between energy release and earthquake magnitude, where the strain-accumulating rate is relative independent of the strain-releasing rate.
针对过去应变积累释放曲线或模型存在的不足,根据GR关系以及能量震级经验关系,推导出一个相对独立的应变积累速率公式。
4) Coulomb stress accumulation rate
库仑应力积累率
1.
We caculate Coulomb stress accumulation rate and moment accumulation rate through inversing Haiyuan fault slipping rates and locking depths by using a Fourier solution of 3D body force model with constrains of CMONOC and GPS profiles data.
用中国地壳运动观测网络区域站在海原断裂带附近的所有观测数据及跨断裂GPS剖面观测数据作为约束,用Smith3D体力模型反演了海原断裂带断层滑动速率和断层闭锁深度,计算了库仑应力积累率和地震矩积累率。
5) Accumulation rate
积累速率
1.
Preliminary results from recent traverse along a route across its inland accumulation area show that the accumulation rate in this area is very low, not exceeding 150 kg/ (m￣2 a) at most sites.
近几年对该冰流源区的路线考察表明，该地区积累速率相当低，大部分观测点低于１５０ｋｇ／（ｍ￣２·ａ）。
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条