1) Stress adjustment element
应力调整单元
2) Adjustment unit
调整单元
1.
One fault, moves and the other fault does not move, so the single main shock type is formed when the internal angle region of conjugate faults is located in compressive stress region and there exists the adjustment unit of adequate size in the intersection region of Conju gat.
本文根据震源组合模式,利用有限元方法模拟计算,研究了共轭发震构造间的相互作用,结果如下:(1)当共轭断层的内角为压区且断层交汇区存在一定尺度的调整单元时,只有一条断层发震,另一条断层并不发震。
4) stress element
应力单元
1.
A new stress element near a hole which satisfies both the stress boundary conditions at the hole and at the surface of the laminate and stress continuity condition at the interface is developed.
构造了一个满足孔边应力边界条件、层间应力连续条件以及层合板表面应力边界条件的孔边应力单元。
5) stress adjusting method
应力调整法
1.
Ultimate stress method is presented,including stress adjusting method,compressive area method and stress and settlement decomposition method.
提出复合桩基沉降计算的最终应力法 ,包括简化应力调整法、压缩区域分解法和应力与沉降分解法 ,并给出了两个工程实例。
6) Stress re-adjusting zone
应力调整区
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条