1) modal part
模部
1.
Reconstruction of liquid free slosh modes by curved quiet free surface was investigated in the case of small bond number by means of modal part analysis method in this paper.
运用模部分析方法考察了小 Ｂｏｎｄ 数条件下圆柱贮箱中弯曲静液面对液体晃动模态的重构作用· 研究表明，圆柱贮箱中的液体作小幅晃动时，参与晃动的各阶基本模态的正交性若仅由 Ｂｅｓｓｅｌ 模部来给出，则弯曲静液面将使各阶模态加权耦合，形成新的特征模态；参与晃动的各阶基本模态的正交性若由三角函数模部来给出，则弯曲静液面将独立改变各阶模态的固有频率，各阶模态之间不耦合· 运用新的重构模态来研究圆柱贮箱中液体的横向受迫晃动，给出了其模态选择特征
2) local regression
局部建模
1.
A local regression method based on wavelet transform for near-infrared(NIR)spectral quantitative analysis was proposed.
局部建模方法使用与预测样本相似的样本建立模型,可解决光谱响应与浓度之间的非线性问题,扩大模型的适用范围,提高预测准确度。
3) local dry mold
局部干模
1.
This paper introduces the application of local dry mold in wet mold molding, the process design of local dry mold, making demands of upper and under mold board core,and also gives typical examples.
介绍了局部干模在潮模造型中的应用,及局部干模的工艺结构设计和上、下盖板芯的制作要求,并提供了应用的典型事例。
4) Chest phantom
胸部体模
1.
Methods Simulated reticular,linear,and nodular structures were located in an anthropomorphic chest phantom.
方法在仿真胸部体模中放置模拟网状、线状和结节病变结构,用不同曝光剂量组采集CR图像。
5) pulmonary model of human
肺部模型
1.
In order to get the distribution of human lung tissue,according to CT scanning image of human lung,a pulmonary model of human was established combined with the structure property of human lung tissue using the software COMSOL.
为获取人体肺部组织分布,结合人体肺部组织的结构特征,运用大型有限元仿真软件COMSOL,根据CT肺部扫描图像构建人体肺部模型,同时结合人体组织和器官电导率分布参数等信息,并考虑肺部先验知识,采用共轭梯度算法重建被测场电导率分布图像。
6) head model
头部模型
补充资料：神经元形态突触末梢部切面模示图
李瑞端绘
[图]
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条