说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 固有温度
1)  proper temperature
固有温度
2)  Curing temperature
固化温度
1.
Influence of Curing Temperature on Performance of Epoxy Thermosets
固化温度对环氧树脂固化物性能的影响
2.
Effects of curing temperature and filler content on the performance of epoxy adhesive for restoration of cultural relic
固化温度及填料对文物环氧胶粘剂性能的影响
3.
The different curing temperature effect on the microstructures and properties of epoxy/rectorite nanocomposites were studied using X-ray diffraction (XRD) and dynamical mechanical analysis (DMA).
利用X衍射、动态力学分析(DMA)研究了不同的固化温度对环氧树脂/累托土纳米复合结构的性能及微结构的影响。
3)  solution temperature
固溶温度
1.
Effect of solid solution temperatures on the mechanical properties and microstructure of sand-cast samples of ZL210A cast aluminum alloy;
固溶温度对ZL210A铸造铝合金砂型试样力学性能和微观组织的影响
2.
Effects of solution temperature on precipitation of β-Mg_(17)Al_(12) phase and mechanical properties of AZ80 magnesium alloy;
固溶温度对AZ80镁合金析出相β-Mg_(17)Al_(12)及性能的影响
3.
Influence of solution temperature on microstructure and toughness of weld joint in 2205 duplex stainless steel
固溶温度对2205双相不锈钢焊缝组织与韧性的影响
4)  solidification temperature
凝固温度
1.
Solidification Temperature of Concasting Mold Fluxes;
连铸结晶器保护渣的凝固温度
2.
The results show that with increasing amounts of added TiO2, the viscosity and solidification temperature (θs) of the MF decrease gradually, and then increase rapidly.
研究表明:随着TiO2加入量的增加,MF的黏度和凝固温度(θs)先逐渐减小而后迅速增大。
3.
The results showed that the viscosity of mold fluxes could be decreased by TiO2,except that perovskite was precipitated that could increase viscosity and solidification temperature.
研究表明,TiO2可以降低连铸保护渣的粘度,但随着钙钛矿的析出,会增加凝固温度和粘度。
5)  solidifying temperature
固化温度
1.
When the temperature of the point ,1/3 δ away from plastics product center, arrives at solidifying temperature,the caculation formula accords with more accurately producing practice.
当选取距塑件中心 1/3δ处的固化温度作为开模温度 ,推出的计算公式更加符合生产实际。
6)  solid temperature
固体温度
1.
The influence of the solid temperature changeful of the laser field on photoacoustce signal intensity is studied.
研究了激光场中固体温度的变化对光声信号强度的影响 。
补充资料:铂电阻温度表(见电阻温度表)


铂电阻温度表(见电阻温度表)


表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条