1) pulse test
脉搏测试
2) pulse tester
脉搏测试仪
1.
This paper introduces the implementation of the wireless remote control of pulse tester that takes C8051F020 microcontroller chips as the main control chip,adopts codec chipset PT2262/PT2272 and is equipped with RF transmitting /receiving modules.
介绍了以C8051F020单片机为主要控制芯片,同时采用编解码芯片组PT2262/PT2272,配以射频发射、接收模块实现脉搏测试仪的无线遥控。
3) digital display sphygmometer
数显式脉搏测试仪
1.
This paper introduces a kind of digital display sphygmometer by using hardware descriptive language VHDL combined with CPLD/FPGA design.
简述了在EDA平台上利用硬件描述语言VHDL结合CPLD/FPGA器件,设计了一种数显式脉搏测试仪。
4) Pulse
脉搏
1.
Investigation on Pulse and Pressure of Primary and Middle School Students in Linyi City in 2005;
2005年临沂市部分城乡中小学生脉搏、血压调查
2.
Changes of Gaoyuankang Capsule on the Pulse Before and after Exercise under the High Altitude Condition;
高原康胶囊对人体在高原环境下运动前后脉搏的影响
3.
Method of pulse measurement based on optoelectronic technology;
基于光电技术的脉搏测量方法
5) Pulse-Parameters
脉搏参数
6) pulse wave
脉搏波
1.
Method of removing respiratory interference from pulse wave;
脉搏波中呼吸干扰的去除
2.
Rectification of the cardiac output computation based on radial pulse wave hemodynamic detecting;
基于桡动脉脉搏波血流动力学检测的心输出量计算修正
3.
A theoretical study on relations between physiological factors and pulse wave characteristics;
血流脉搏波的特征与生理因素的相关性研究
参考词条
补充资料:测试结果可接受性的检查和最终测试结果的确定
测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result
C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
说明:补充资料仅用于学习参考,请勿用于其它任何用途。