2) impact abrasive wear
冲击磨料磨损
1.
The impact abrasive wear properties of low-carbon high alloy steel were tested under the experimental condition,and then the digital simulation experiment of this test was done with the finite element analysis software ANSYS in virtual environment.
在实验室条件下对低碳高合金钢进行了冲击磨料磨损试验,然后运用ANSYS有限元分析工具,在虚拟环境下对该试验进行数字仿真,通过分析冲击磨损形貌、亚表层金相以及数字仿真所得到的冲击过程中材料的应力分布情况,讨论了试验中观察到的白层的形成机制和失效模式。
2.
Through the researches in some material's properties to resist impact abrasive wear, optimized 20CrMnTi optimized was further tested under the condition of impacting ? wear, sliding abrasive wear and impact abrasive wear, analyzed its characteristics, and discussed the appearance and forming mechanism observed.
通过对多种材料在不同试验条件下耐冲击磨料磨损性能的初步研究 ,优选出 2 0CrMnTi材料开展了在冲击磨损、滑动磨料磨损和冲击磨料磨损条件下的进一步试验 ,分析了在各磨损与变形条件下的特点 ,对所观察到的现象与机理进行了讨论 ,得出了一些有益结论。
3.
The impact abrasive wear behavious of super-high manganese steel were investigatedthrough dynamic abrasion test and hardness measurement, and by using SEM and TEM the worn surfacemorphology and microstructure observed.
本文通过动载磨料磨损实验和硬度测量，利用SEM和TEM观察磨损表面形貌和微观组织，研究了超高锰钢的冲击磨料磨损行为。
3) impact and slid ing abrasion
冲击滑动磨料磨损
4) high-stress impact abrasion
高应力冲击磨料磨损
1.
Eutectic composition should be adopted for high-Cr white cast iron used under high-stress impact abrasion condition.
高应力冲击磨料磨损时,高铬白口铸铁应选共晶成分。
5) three body impact abrasive wear
三体冲击磨料磨损
6) abrasive wear under weak impact
非强冲击磨料磨损
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条