1) breakdown
破压
1.
ome reasons of rotor coils breakdown for WJL-2442-8 type brushless exciterare analyzed, and the process for their repairing is raised in this paper
分析了ＷＪＬ—２４４２—８型无刷励磁机转子线圈破压的原因，并提出了修理的工艺方法。
2) burst pressure
爆破压力
1.
Study of burst pressure calculation method of pipelines with axial flaws;
含轴向缺陷管道的爆破压力计算方法研究
2.
The burst pressure of filament wound pressure vessels and the ratio of strength transfer of fiber;
纤维缠绕压力容器的爆破压力与纤维强度转换率
3.
The strain distributions were measured,and the stress concentration and yield limit load and burst pressure were analyzed.
完成了一组管道修复结构的全尺寸爆破与疲劳实验,测量了修复结构中的应变分布,分析了应力集中、屈服极限压力和爆破压力等因素。
3) Explosion Pressure
爆破压力
1.
On the basis of the test results of a full scale hot state explosion test a calculation and analysis was conducted of the explosion pressure of the following: square box test parts, nodular cast iron boiler, grey cast iron boiler and grey cast iron boiler plates.
基于一次大规模热态爆破试验的结果 ,分别对方箱试件、球墨铸铁锅炉的爆破压力、灰口铸铁锅炉和灰口铸铁锅片的爆破压力进行了计算和分析 ,得出安全系数选取的推荐值。
4) breakthrough pressure
突破压力
1.
Determination of the plugging position of water shutoff agent by breakthrough pressure method.;
用突破压力法确定堵剂在油藏中的封堵位置
2.
Exploration practices in the Jiyang Depression of the Bohai Bay Basin have indicated that,under the same dynamic condition of oil and gas pool forming,resistivity(breakthrough pressure) of entrance and exit interface is different,so fluid enters reservoir and pore respectively.
渤海湾盆地济阳坳陷的勘探实践表明,同一成藏动力条件下,油气充注成藏过程中油气等流体突破储层进/出口界面的抵抗力(突破压力)存在差异,导致选择性地进入储集体和孔隙。
3.
8% after the water of 50 PV is injected;The breakthrough pressure gradient is not lower t.
8%,突破压力梯度一般不低于3。
5) bursting pressure
爆破压力
1.
In this article, the influence of thickness reduction due to big deformation for bursting pressure of multilayered cylinder & spherical shells is analyzed.
用强度削弱系数分析了因大变形引起的壁厚减薄对多层容器爆破压力的影响 ,导出了多层圆筒形容器与球形容器爆破压力计算公式。
2.
By using mathematic model and Tresca yield criteria the total yield pressure and bursting pressure of flat ribbon-wound pressure vessel were discussed,the simple calculation formula for bursting pressure of flat ribbon-wound pressure vessel was given,the certification of practical example calculation was made for the accuracy and fineness of the calculated value.
通过数学模型,应用Tresca屈服准则,探讨了扁平绕带式压力容器的全屈服压力和爆破压力,给出了扁平绕带式压力容器爆破压力的简便计算公式,对计算值的准确度和精密度进行了实例计算验证。
3.
Based on that mechanism, the calculation formula for bursting pressure is derived.
通过实验得出正拱环向开缝型爆破片的破坏机理,由此导出正拱环向开缝型爆破片的爆破压力计算公式。
6) burst pressure
爆破压强
1.
On the basis of the netting analysis,the calculating methods of the wall thickness and the burst pressure of the filamentwound cylinder for the solid rocket motor are obtained.
基于网格理论,得到了固体火箭发动机纤维缠绕壳体圆筒壁厚和爆破压强的计算方法,给出了用模拟实验压力容器确定纤维发挥强度的方法。
参考词条
补充资料：破梆破羣
1.旧时牌戏术语。二条﹑二万﹑八饼一副叫"梆子";三条﹑三万﹑七饼一副叫"羣子"。梆子中缺饼子叫"破梆"，群子中缺饼子叫"破羣"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。